Re: [PATCH V1 1/3] dt-bindings: ufs: qcom: Document ice configuration table

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, Oct 05, 2024 at 12:13:05PM +0530, Ram Kumar Dwivedi wrote:
> There are three algorithms supported for inline crypto engine:
> Floor based, Static and Instantaneous algorithm.
> 
> Document the compatible used for the algorithm configurations
> for inline crypto engine found.
> 
> Co-developed-by: Naveen Kumar Goud Arepalli <quic_narepall@xxxxxxxxxxx>
> Signed-off-by: Naveen Kumar Goud Arepalli <quic_narepall@xxxxxxxxxxx>
> Co-developed-by: Nitin Rawat <quic_nitirawa@xxxxxxxxxxx>
> Signed-off-by: Nitin Rawat <quic_nitirawa@xxxxxxxxxxx>
> Signed-off-by: Ram Kumar Dwivedi <quic_rdwivedi@xxxxxxxxxxx>
> ---
>  .../devicetree/bindings/ufs/qcom,ufs.yaml     | 24 +++++++++++++++++++
>  1 file changed, 24 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/ufs/qcom,ufs.yaml b/Documentation/devicetree/bindings/ufs/qcom,ufs.yaml
> index 25a5edeea164..5ac56e164643 100644
> --- a/Documentation/devicetree/bindings/ufs/qcom,ufs.yaml
> +++ b/Documentation/devicetree/bindings/ufs/qcom,ufs.yaml
> @@ -108,6 +108,11 @@ properties:
>      description:
>        GPIO connected to the RESET pin of the UFS memory device.
>  
> +  ice-config:
> +    type: object
> +    description:
> +      ICE configuration table for Qualcom SOC

What goes in this node?

> +
>  required:
>    - compatible
>    - reg
> @@ -350,5 +355,24 @@ examples:
>                              <0 0>,
>                              <0 0>;
>              qcom,ice = <&ice>;
> +
> +            ice_cfg: ice-config {
> +                alg1 {
> +                     alg-name = "alg1";
> +                     rx-alloc-percent = <60>;
> +                     status = "disabled";

Examples should be enabled.

> +                };
> +
> +                alg2 {
> +                     alg-name = "alg2";
> +                     status = "disabled";
> +                };
> +
> +                alg3 {
> +                     alg-name = "alg3";
> +                     num-core = <28 28 15 13>;
> +                     status = "ok";
> +                };
> +            };
>          };
>      };
> -- 
> 2.46.0
> 




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux