On Tue, Jul 30, 2024 at 12:00:13PM GMT, Stephan Gerhold wrote:
> On Mon, Jul 29, 2024 at 01:57:25PM -0700, Rob Clark wrote:
> > From: Rob Clark <robdclark@xxxxxxxxxxxx>
> >
> > Use the correct panel compatible, and wire up enable-gpio. It is wired
> > up in the same way as the x1e80100-crd.
> >
> > Signed-off-by: Rob Clark <robdclark@xxxxxxxxxxxx>
> > Reviewed-by: Abel Vesa <abel.vesa@xxxxxxxxxx>
> > ---
> > Note that the power-source differs from the CRD. Figured that out by
> > diffing $debugfs/gpio.
> >
> > .../dts/qcom/x1e80100-lenovo-yoga-slim7x.dts | 17 +++++++++++++++--
> > 1 file changed, 15 insertions(+), 2 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts b/arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts
> > index 70977e9fa266..6f8d52c368a4 100644
> > --- a/arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts
> > +++ b/arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts
> > [...]
> > @@ -669,6 +672,16 @@ &pcie6a_phy {
> > status = "okay";
> > };
> >
> > +&pmc8380_3_gpios {
> > + edp_bl_en: edp-bl-en-state {
> > + pins = "gpio4";
> > + function = "normal";
> > + power-source = <0>; /* 1.8V */
>
> Hm, are you sure the firmware sets it like this?
>
> power-source = <0> is typically VPH, i.e. the main battery supply
> voltage or similar. This will definitely be higher than 1.8V. It seems a
> bit odd to use a variable voltage source for a GPIO...
As you've mentioned it. Please use defined values rather than just <0>
for power-source property.
--
With best wishes
Dmitry
