All three USB SS combo QMP PHYs need to power off, deinit, then init and
power on again on every plug in event. This is done by forwarding the
orientation from the retimer/mux to the PHY. All is needed is the
orientation-switch property in each such PHY devicetree node. So add
them.
Fixes: 4af46b7bd66f ("arm64: dts: qcom: x1e80100: Add USB nodes")
Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/x1e80100.dtsi | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/x1e80100.dtsi b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
index 6abff8258674..8a577f29d4d4 100644
--- a/arch/arm64/boot/dts/qcom/x1e80100.dtsi
+++ b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
@@ -2604,6 +2604,8 @@ usb_1_ss0_qmpphy: phy@fd5000 {
#clock-cells = <1>;
#phy-cells = <1>;
+ orientation-switch;
+
status = "disabled";
ports {
@@ -2672,6 +2674,8 @@ usb_1_ss1_qmpphy: phy@fda000 {
#clock-cells = <1>;
#phy-cells = <1>;
+ orientation-switch;
+
status = "disabled";
ports {
@@ -2740,6 +2744,8 @@ usb_1_ss2_qmpphy: phy@fdf000 {
#clock-cells = <1>;
#phy-cells = <1>;
+ orientation-switch;
+
status = "disabled";
ports {
---
base-commit: b18bbfc14a38b5234e09c2adcf713e38063a7e6e
change-id: 20240829-x1e80100-combo-qmpphys-add-orientation-switch-afc7f6f25137
Best regards,
--
Abel Vesa <abel.vesa@xxxxxxxxxx>
