Add the UFS Host Controller node. This was basically copied from the
arch/arm64/boot/dts/qcom/sc7180.dtsi file.
Signed-off-by: Marcus Glocker <marcus@xxxxxxxxx>
Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/x1e80100.dtsi | 72 ++++++++++++++++++++++++++
1 file changed, 72 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/x1e80100.dtsi b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
index 7bca5fcd7d52..9f01b3ff3737 100644
--- a/arch/arm64/boot/dts/qcom/x1e80100.dtsi
+++ b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
@@ -2878,6 +2878,78 @@ mmss_noc: interconnect@1780000 {
#interconnect-cells = <2>;
};
+ ufs_mem_hc: ufs@1d84000 {
+ compatible = "qcom,x1e80100-ufshc", "qcom,ufshc",
+ "jedec,ufs-2.0";
+ reg = <0 0x01d84000 0 0x3000>;
+ interrupts = <GIC_SPI 265 IRQ_TYPE_LEVEL_HIGH>;
+ phys = <&ufs_mem_phy>;
+ phy-names = "ufsphy";
+ lanes-per-direction = <1>;
+ #reset-cells = <1>;
+ resets = <&gcc GCC_UFS_PHY_BCR>;
+ reset-names = "rst";
+
+ power-domains = <&gcc GCC_UFS_PHY_GDSC>;
+
+ iommus = <&apps_smmu 0xa0 0x0>;
+
+ clock-names = "core_clk",
+ "bus_aggr_clk",
+ "iface_clk",
+ "core_clk_unipro",
+ "ref_clk",
+ "tx_lane0_sync_clk",
+ "rx_lane0_sync_clk";
+ clocks = <&gcc GCC_UFS_PHY_AXI_CLK>,
+ <&gcc GCC_AGGRE_UFS_PHY_AXI_CLK>,
+ <&gcc GCC_UFS_PHY_AHB_CLK>,
+ <&gcc GCC_UFS_PHY_UNIPRO_CORE_CLK>,
+ <&rpmhcc RPMH_CXO_CLK>,
+ <&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>,
+ <&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>;
+ freq-table-hz = <50000000 200000000>,
+ <0 0>,
+ <0 0>,
+ <37500000 150000000>,
+ <0 0>,
+ <0 0>,
+ <0 0>;
+
+ interconnects = <&aggre1_noc MASTER_UFS_MEM QCOM_ICC_TAG_ALWAYS
+ &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
+ <&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS
+ &config_noc SLAVE_UFS_MEM_CFG QCOM_ICC_TAG_ALWAYS>;
+ interconnect-names = "ufs-ddr", "cpu-ufs";
+
+ qcom,ice = <&ice>;
+
+ status = "disabled";
+ };
+
+ ufs_mem_phy: phy@1d87000 {
+ compatible = "qcom,x1e80100-qmp-ufs-phy";
+ reg = <0 0x01d87000 0 0x1000>;
+ clocks = <&rpmhcc RPMH_CXO_CLK>,
+ <&gcc GCC_UFS_PHY_PHY_AUX_CLK>,
+ <&tcsr TCSR_UFS_PHY_CLKREF_EN>;
+ clock-names = "ref",
+ "ref_aux",
+ "qref";
+ power-domains = <&gcc GCC_UFS_PHY_GDSC>;
+ resets = <&ufs_mem_hc 0>;
+ reset-names = "ufsphy";
+ #phy-cells = <0>;
+ status = "disabled";
+ };
+
+ ice: crypto@1d90000 {
+ compatible = "qcom,x1e80100-inline-crypto-engine",
+ "qcom,inline-crypto-engine";
+ reg = <0 0x01d90000 0 0x8000>;
+ clocks = <&gcc GCC_UFS_PHY_ICE_CORE_CLK>;
+ };
+
pcie6a: pci@1bf8000 {
device_type = "pci";
compatible = "qcom,pcie-x1e80100";
--
2.39.2
