[PATCH v2 4/7] arm64: dts: qcom: Add UFS node

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Add the UFS Host Controller node.  This was basically copied from the
arch/arm64/boot/dts/qcom/sc7180.dtsi file.

Signed-off-by: Marcus Glocker <marcus@xxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/x1e80100.dtsi | 71 ++++++++++++++++++++++++++
 1 file changed, 71 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/x1e80100.dtsi b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
index 7bca5fcd7d52..235e20e4b51f 100644
--- a/arch/arm64/boot/dts/qcom/x1e80100.dtsi
+++ b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
@@ -2878,6 +2878,77 @@ mmss_noc: interconnect@1780000 {
 			#interconnect-cells = <2>;
 		};
 
+		ufs_mem_hc: ufs@1d84000 {
+			compatible = "qcom,x1e80100-ufshc", "qcom,ufshc",
+				     "jedec,ufs-2.0";
+			reg = <0 0x01d84000 0 0x3000>;
+			interrupts = <GIC_SPI 265 IRQ_TYPE_LEVEL_HIGH>;
+			phys = <&ufs_mem_phy>;
+			phy-names = "ufsphy";
+			lanes-per-direction = <1>;
+			#reset-cells = <1>;
+			resets = <&gcc GCC_UFS_PHY_BCR>;
+			reset-names = "rst";
+
+			power-domains = <&gcc GCC_UFS_PHY_GDSC>;
+
+			iommus = <&apps_smmu 0xa0 0x0>;
+
+			clock-names = "core_clk",
+				      "bus_aggr_clk",
+				      "iface_clk",
+				      "core_clk_unipro",
+				      "ref_clk",
+				      "tx_lane0_sync_clk",
+				      "rx_lane0_sync_clk";
+			clocks = <&gcc GCC_UFS_PHY_AXI_CLK>,
+				 <&gcc GCC_AGGRE_UFS_PHY_AXI_CLK>,
+				 <&gcc GCC_UFS_PHY_AHB_CLK>,
+				 <&gcc GCC_UFS_PHY_UNIPRO_CORE_CLK>,
+				 <&rpmhcc RPMH_CXO_CLK>,
+				 <&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>,
+				 <&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>;
+			freq-table-hz = <50000000 200000000>,
+					<0 0>,
+					<0 0>,
+					<37500000 150000000>,
+					<0 0>,
+					<0 0>,
+					<0 0>;
+
+			interconnects = <&aggre1_noc MASTER_UFS_MEM QCOM_ICC_TAG_ALWAYS
+					 &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
+					<&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS
+					 &config_noc SLAVE_UFS_MEM_CFG QCOM_ICC_TAG_ALWAYS>;
+			interconnect-names = "ufs-ddr", "cpu-ufs";
+
+			qcom,ice = <&ice>;
+
+			status = "disabled";
+		};
+
+		ufs_mem_phy: phy@1d87000 {
+			compatible = "qcom,x1e80100-qmp-ufs-phy";
+			reg = <0 0x01d87000 0 0x1000>;
+			clocks = <&rpmhcc RPMH_CXO_CLK>,
+				 <&gcc GCC_UFS_PHY_PHY_AUX_CLK>;
+			clock-names = "ref",
+				      "ref_aux",
+				      "qref";
+			power-domains = <&gcc GCC_UFS_PHY_GDSC>;
+			resets = <&ufs_mem_hc 0>;
+			reset-names = "ufsphy";
+			#phy-cells = <0>;
+			status = "disabled";
+		};
+
+		ice: crypto@1d90000 {
+			compatible = "qcom,x1e80100-inline-crypto-engine",
+				     "qcom,inline-crypto-engine";
+			reg = <0 0x01d90000 0 0x8000>;
+			clocks = <&gcc GCC_UFS_PHY_ICE_CORE_CLK>;
+		};
+
 		pcie6a: pci@1bf8000 {
 			device_type = "pci";
 			compatible = "qcom,pcie-x1e80100";
-- 
2.39.2





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux