Re: [PATCH 13/14] PCI: qcom: Simulate PCIe hotplug using 'global' interrupt

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 15.07.2024 7:33 PM, Manivannan Sadhasivam via B4 Relay wrote:
> From: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> 
> Historically, Qcom PCIe RC controllers lack standard hotplug support. So
> when an endpoint is attached to the SoC, users have to rescan the bus
> manually to enumerate the device. But this can be avoided by simulating the
> PCIe hotplug using Qcom specific way.
> 
> Qcom PCIe RC controllers are capable of generating the 'global' SPI
> interrupt to the host CPUs. The device driver can use this event to
> identify events such as PCIe link specific events, safety events etc...
> 
> One such event is the PCIe Link up event generated when an endpoint is
> detected on the bus and the Link is 'up'. This event can be used to
> simulate the PCIe hotplug in the Qcom SoCs.
> 
> So add support for capturing the PCIe Link up event using the 'global'
> interrupt in the driver. Once the Link up event is received, the bus
> underneath the host bridge is scanned to enumerate PCIe endpoint devices,
> thus simulating hotplug.
> 
> All of the Qcom SoCs have only one rootport per controller instance. So
> only a single 'Link up' event is generated for the PCIe controller.
> 
> Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> ---

Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>

Konrad




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux