Add the accelerometer and magnetometer that are present on the Motorola
Moto G (2013) device.
Signed-off-by: Stanislav Jakubek <stano.jakubek@xxxxxxxxx>
---
.../boot/dts/qcom/msm8226-motorola-falcon.dts | 53 +++++++++++++++++++
1 file changed, 53 insertions(+)
diff --git a/arch/arm/boot/dts/qcom/msm8226-motorola-falcon.dts b/arch/arm/boot/dts/qcom/msm8226-motorola-falcon.dts
index 029e1b1659c9..5dbca83f2230 100644
--- a/arch/arm/boot/dts/qcom/msm8226-motorola-falcon.dts
+++ b/arch/arm/boot/dts/qcom/msm8226-motorola-falcon.dts
@@ -96,6 +96,35 @@ reserved@fb00000 {
};
};
+&blsp1_i2c2 {
+ status = "okay";
+
+ magnetometer@c {
+ compatible = "asahi-kasei,ak8963";
+ reg = <0xc>;
+ interrupts-extended = <&tlmm 66 IRQ_TYPE_EDGE_FALLING>;
+ reset-gpios = <&tlmm 62 GPIO_ACTIVE_LOW>;
+ vdd-supply = <&pm8226_l19>;
+ vid-supply = <&pm8226_lvs1>;
+ pinctrl-0 = <&mag_int_default &mag_reset_default>;
+ pinctrl-names = "default";
+ };
+
+ accelerometer@19 {
+ compatible = "st,lis3dh-accel";
+ reg = <0x19>;
+ interrupts-extended = <&tlmm 63 IRQ_TYPE_EDGE_FALLING>;
+ vdd-supply = <&pm8226_l19>;
+ vddio-supply = <&pm8226_lvs1>;
+ pinctrl-0 = <&accel_int_default>;
+ pinctrl-names = "default";
+ mount-matrix = "0", "1", "0",
+ "1", "0", "0",
+ "0", "0", "-1";
+ st,drdy-int-pin = <1>;
+ };
+};
+
&blsp1_i2c3 {
status = "okay";
@@ -321,6 +350,30 @@ &smbb {
};
&tlmm {
+ accel_int_default: accel-int-default-state {
+ pins = "gpio63";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ output-disable;
+ };
+
+ mag_int_default: mag-int-default-state {
+ pins = "gpio66";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ output-disable;
+ };
+
+ mag_reset_default: mag-reset-default-state {
+ pins = "gpio62";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ output-high;
+ };
+
reg_lcd_default: reg-lcd-default-state {
pins = "gpio31", "gpio33";
function = "gpio";
--
2.34.1
