On Mon, Jun 03, 2024 at 11:26:28AM +0200, Johan Hovold wrote: > On Mon, Jun 03, 2024 at 11:49:51AM +0300, Dmitry Baryshkov wrote: > > On Mon, 3 Jun 2024 at 11:48, Johan Hovold <johan@xxxxxxxxxx> wrote: > > > On Mon, May 27, 2024 at 11:07:28AM +0300, Abel Vesa wrote: > > > > Add the pmic-glink node and describe all 3 USB Type-C connectors. Do this > > > > for USB only, for now. The DP port will come at a later stage since it > > > > uses a retimer. > > > > With this series applied, I'm getting the following error on boot of the > > > CRD: > > > > > > ucsi_glink.pmic_glink_ucsi pmic_glink.ucsi.0: PPM init failed, stop trying > > > > > > Known issue? Do you need to enable some quirk in the UCSI driver? > > > > Not that I know. The message is caused by the UCSI not responding to > > the PPM_RESET command. A trace from pmic-glink would be helpful. > > I don't have time to look into this right now, so only reporting to > Abel. Not having the hardware and not having the dumps I probalby can't help either. > Looks like there are two more warnings earlier on boot which appear to > be related: > > [ 10.730571] ucsi_glink.pmic_glink_ucsi pmic_glink.ucsi.0: invalid connector number, ignoring > [ 10.730656] pmic_glink_altmode.pmic_glink_altmode pmic_glink.altmode.0: invalid connector number, ignoring It well might be. -- With best wishes Dmitry
