On Thu, May 30, 2024 at 03:45:53PM GMT, Douglas Anderson wrote: > For UART devices the M_GP_LENGTH is the TX word count. For other > devices this is the transaction word count. > > For UART devices the S_GP_LENGTH is the RX word count. > > The IRQ_EN set/clear registers allow you to set or clear bits in the > IRQ_EN register without needing a read-modify-write. > Acked-by: Bjorn Andersson <andersson@xxxxxxxxxx> Regards, Bjorn > Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx> > --- > Since these new definitions are used in the future UART patches the > hope is that they could be acked by Qualcomm folks and then go through > the same tree as the UART patches that need them. > > Changes in v2: > - New > > include/linux/soc/qcom/geni-se.h | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/include/linux/soc/qcom/geni-se.h b/include/linux/soc/qcom/geni-se.h > index 0f038a1a0330..8d07c442029b 100644 > --- a/include/linux/soc/qcom/geni-se.h > +++ b/include/linux/soc/qcom/geni-se.h > @@ -88,11 +88,15 @@ struct geni_se { > #define SE_GENI_M_IRQ_STATUS 0x610 > #define SE_GENI_M_IRQ_EN 0x614 > #define SE_GENI_M_IRQ_CLEAR 0x618 > +#define SE_GENI_M_IRQ_EN_SET 0x61c > +#define SE_GENI_M_IRQ_EN_CLEAR 0x620 > #define SE_GENI_S_CMD0 0x630 > #define SE_GENI_S_CMD_CTRL_REG 0x634 > #define SE_GENI_S_IRQ_STATUS 0x640 > #define SE_GENI_S_IRQ_EN 0x644 > #define SE_GENI_S_IRQ_CLEAR 0x648 > +#define SE_GENI_S_IRQ_EN_SET 0x64c > +#define SE_GENI_S_IRQ_EN_CLEAR 0x650 > #define SE_GENI_TX_FIFOn 0x700 > #define SE_GENI_RX_FIFOn 0x780 > #define SE_GENI_TX_FIFO_STATUS 0x800 > @@ -101,6 +105,8 @@ struct geni_se { > #define SE_GENI_RX_WATERMARK_REG 0x810 > #define SE_GENI_RX_RFR_WATERMARK_REG 0x814 > #define SE_GENI_IOS 0x908 > +#define SE_GENI_M_GP_LENGTH 0x910 > +#define SE_GENI_S_GP_LENGTH 0x914 > #define SE_DMA_TX_IRQ_STAT 0xc40 > #define SE_DMA_TX_IRQ_CLR 0xc44 > #define SE_DMA_TX_FSM_RST 0xc58 > -- > 2.45.1.288.g0e0cd299f1-goog >