There are two ways to describe an eDP panel in device tree. The recommended way is to add a device on the AUX bus, ideally using the edp-panel compatible. The legacy way is to define a top-level platform device for the panel. Document that adding support for eDP panels in a legacy way is strongly discouraged (if not forbidden at all). While we are at it, also drop legacy compatible strings and bindings for five panels. These compatible strings were never used by a DT file present in Linux kernel and most likely were never used with the upstream Linux kernel. The following compatibles were never used by the devices supported by the upstream kernel and are a subject to possible removal: - lg,lp097qx1-spa1 - samsung,lsn122dl01-c01 - sharp,ld-d5116z01b I'm considering dropping them later, unless there is a good reason not to do so. Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx> --- Changes in v2: - Actually drop support for five panels acked by Doug Andersson - Link to v1: https://lore.kernel.org/r/20240523-edp-panel-drop-v1-1-045d62511d09@xxxxxxxxxx --- Dmitry Baryshkov (3): drm/panel-edp: add fat warning against adding new panel compatibles dt-bindings: display: panel-simple: drop several eDP panels drm/panel-edp: drop several legacy panels .../bindings/display/panel/panel-simple.yaml | 10 -- drivers/gpu/drm/panel/panel-edp.c | 191 +++------------------ 2 files changed, 24 insertions(+), 177 deletions(-) --- base-commit: 6dc544b66971c7f9909ff038b62149105272d26a change-id: 20240523-edp-panel-drop-00aa239b3c6b Best regards, -- Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
