From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx> Describe the ath12k WLAN on-board the WCN7850 module present on the board. [Neil: authored the initial version of the change] Co-developed-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx> Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx> Tested-by: Amit Pundir <amit.pundir@xxxxxxxxxx> Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx> --- arch/arm64/boot/dts/qcom/sm8550-qrd.dts | 97 +++++++++++++++++++++++++++++++++ arch/arm64/boot/dts/qcom/sm8550.dtsi | 2 +- 2 files changed, 98 insertions(+), 1 deletion(-) diff --git a/arch/arm64/boot/dts/qcom/sm8550-qrd.dts b/arch/arm64/boot/dts/qcom/sm8550-qrd.dts index 2ed1715000c9..7a15d472bd95 100644 --- a/arch/arm64/boot/dts/qcom/sm8550-qrd.dts +++ b/arch/arm64/boot/dts/qcom/sm8550-qrd.dts @@ -214,6 +214,68 @@ vph_pwr: vph-pwr-regulator { regulator-always-on; regulator-boot-on; }; + + wcn7850-pmu { + compatible = "qcom,wcn7850-pmu"; + + pinctrl-names = "default"; + pinctrl-0 = <&wlan_en>, <&pmk8550_sleep_clk>; + + wlan-enable-gpios = <&tlmm 80 GPIO_ACTIVE_HIGH>; + /* + * TODO Add bt-enable-gpios once the Bluetooth driver is + * converted to using the power sequencer. + */ + + vdd-supply = <&vreg_s5g_0p85>; + vddio-supply = <&vreg_l15b_1p8>; + vddaon-supply = <&vreg_s2g_0p85>; + vdddig-supply = <&vreg_s4e_0p95>; + vddrfa1p2-supply = <&vreg_s4g_1p25>; + vddrfa1p8-supply = <&vreg_s6g_1p86>; + + regulators { + vreg_pmu_rfa_cmn: ldo0 { + regulator-name = "vreg_pmu_rfa_cmn"; + }; + + vreg_pmu_aon_0p59: ldo1 { + regulator-name = "vreg_pmu_aon_0p59"; + }; + + vreg_pmu_wlcx_0p8: ldo2 { + regulator-name = "vreg_pmu_wlcx_0p8"; + }; + + vreg_pmu_wlmx_0p85: ldo3 { + regulator-name = "vreg_pmu_wlmx_0p85"; + }; + + vreg_pmu_btcmx_0p85: ldo4 { + regulator-name = "vreg_pmu_btcmx_0p85"; + }; + + vreg_pmu_rfa_0p8: ldo5 { + regulator-name = "vreg_pmu_rfa_0p8"; + }; + + vreg_pmu_rfa_1p2: ldo6 { + regulator-name = "vreg_pmu_rfa_1p2"; + }; + + vreg_pmu_rfa_1p8: ldo7 { + regulator-name = "vreg_pmu_rfa_1p8"; + }; + + vreg_pmu_pcie_0p9: ldo8 { + regulator-name = "vreg_pmu_pcie_0p9"; + }; + + vreg_pmu_pcie_1p8: ldo9 { + regulator-name = "vreg_pmu_pcie_1p8"; + }; + }; + }; }; &apps_rsc { @@ -808,6 +870,23 @@ &pcie0 { status = "okay"; }; +&pcieport0 { + wifi@0 { + compatible = "pci17cb,1107"; + reg = <0x10000 0x0 0x0 0x0 0x0>; + + vddrfacmn-supply = <&vreg_pmu_rfa_cmn>; + vddaon-supply = <&vreg_pmu_aon_0p59>; + vddwlcx-supply = <&vreg_pmu_wlcx_0p8>; + vddwlmx-supply = <&vreg_pmu_wlmx_0p85>; + vddrfa0p8-supply = <&vreg_pmu_rfa_0p8>; + vddrfa1p2-supply = <&vreg_pmu_rfa_1p2>; + vddrfa1p8-supply = <&vreg_pmu_rfa_1p8>; + vddpcie0p9-supply = <&vreg_pmu_pcie_0p9>; + vddpcie1p8-supply = <&vreg_pmu_pcie_1p8>; + }; +}; + &pcie0_phy { vdda-phy-supply = <&vreg_l1e_0p88>; vdda-pll-supply = <&vreg_l3e_1p2>; @@ -891,6 +970,17 @@ &pon_resin { status = "okay"; }; +&pmk8550_gpios { + pmk8550_sleep_clk: sleep-clk-state { + pins = "gpio3"; + function = "func1"; + input-disable; + output-enable; + bias-disable; + power-source = <0>; + }; +}; + &qupv3_id_0 { status = "okay"; }; @@ -1064,6 +1154,13 @@ wcd_default: wcd-reset-n-active-state { bias-disable; output-low; }; + + wlan_en: wlan-en-state { + pins = "gpio80"; + function = "gpio"; + drive-strength = <8>; + bias-pull-down; + }; }; &uart7 { diff --git a/arch/arm64/boot/dts/qcom/sm8550.dtsi b/arch/arm64/boot/dts/qcom/sm8550.dtsi index 79311a6bd1ad..0e616fdee798 100644 --- a/arch/arm64/boot/dts/qcom/sm8550.dtsi +++ b/arch/arm64/boot/dts/qcom/sm8550.dtsi @@ -1769,7 +1769,7 @@ pcie0: pcie@1c00000 { status = "disabled"; - pcie@0 { + pcieport0: pcie@0 { device_type = "pci"; reg = <0x0 0x0 0x0 0x0 0x0>; bus-range = <0x01 0xff>; -- 2.43.0