[PATCH v5 2/6] drm/msm/dpu: adjust data width for widen bus case

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



data is valid for only half the active window if widebus
is enabled

Signed-off-by: Jun Nie <jun.nie@xxxxxxxxxx>
---
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
index 225c1c7768ff..f97221423249 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
@@ -168,6 +168,15 @@ static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *intf,
 
 	data_width = p->width;
 
+	/*
+	 * If widebus is enabled, data is valid for only half the active window
+	 * since the data rate is doubled in this mode. But for the compression
+	 * mode in DP case, the p->width is already adjusted in
+	 * drm_mode_to_intf_timing_params()
+	 */
+	if (p->wide_bus_en && !dp_intf)
+		data_width = p->width >> 1;
+
 	hsync_data_start_x = hsync_start_x;
 	hsync_data_end_x =  hsync_start_x + data_width - 1;
 

-- 
2.34.1





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux