Re: [PATCH v12 2/6] PCI: qcom: Add ICC bandwidth vote for CPU to PCIe path

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 5/10/2024 12:04 AM, Mayank Rana wrote:
Hi Krishna

On 4/26/2024 6:52 PM, Krishna chaitanya chundru wrote:
To access the host controller registers of the host controller and the
endpoint BAR/config space, the CPU-PCIe ICC (interconnect) path should
be voted otherwise it may lead to NoC (Network on chip) timeout.
We are surviving because of other driver voting for this path.

As there is less access on this path compared to PCIe to mem path
add minimum vote i.e 1KBps bandwidth always which is sufficient enough
to keep the path active and is recommended by HW team.

During S2RAM (Suspend-to-RAM), the DBI access can happen very late (while
disabling the boot CPU). So do not disable the CPU-PCIe interconnect path
during S2RAM as that may lead to NoC error.

Reviewed-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
Signed-off-by: Krishna chaitanya chundru <quic_krichai@xxxxxxxxxxx>
---
  drivers/pci/controller/dwc/pcie-qcom.c | 44 ++++++++++++++++++++++++++++++----
  1 file changed, 40 insertions(+), 4 deletions(-)

diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index 14772edcf0d3..465d63b4be1c 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -245,6 +245,7 @@ struct qcom_pcie {
      struct phy *phy;
      struct gpio_desc *reset;
      struct icc_path *icc_mem;
+    struct icc_path *icc_cpu;
      const struct qcom_pcie_cfg *cfg;
      struct dentry *debugfs;
      bool suspended;
@@ -1409,6 +1410,9 @@ static int qcom_pcie_icc_init(struct qcom_pcie *pcie)
      if (IS_ERR(pcie->icc_mem))
          return PTR_ERR(pcie->icc_mem);
+    pcie->icc_cpu = devm_of_icc_get(pci->dev, "cpu-pcie");
+    if (IS_ERR(pcie->icc_cpu))
+        return PTR_ERR(pcie->icc_cpu);
      /*
       * Some Qualcomm platforms require interconnect bandwidth constraints
       * to be set before enabling interconnect clocks.
@@ -1418,7 +1422,20 @@ static int qcom_pcie_icc_init(struct qcom_pcie *pcie)
       */
      ret = icc_set_bw(pcie->icc_mem, 0, QCOM_PCIE_LINK_SPEED_TO_BW(1));
      if (ret) {
-        dev_err(pci->dev, "failed to set interconnect bandwidth: %d\n",
+        dev_err(pci->dev, "Failed to set bandwidth for PCIe-MEM interconnect path: %d\n",
+            ret);
+        return ret;
+    }
+
+    /*
+     * Since the CPU-PCIe path is only used for activities like register
+     * access of the host controller and endpoint Config/BAR space access, +     * HW team has recommended to use a minimal bandwidth of 1KBps just to
+     * keep the path active.
+     */
+    ret = icc_set_bw(pcie->icc_cpu, 0, kBps_to_icc(1));
+    if (ret) {
+        dev_err(pci->dev, "Failed to set bandwidth for CPU-PCIe interconnect path: %d\n",
              ret);
Is it needed to undo icc_mem related bus bandwidth vote here ?
I will add the logic to remove icc_mem path while returning from here,
in the next patch series.

- Krishna Chaitanya.
          return ret;
      }
@@ -1448,7 +1465,7 @@ static void qcom_pcie_icc_update(struct qcom_pcie *pcie)       ret = icc_set_bw(pcie->icc_mem, 0, width * QCOM_PCIE_LINK_SPEED_TO_BW(speed));
      if (ret) {
-        dev_err(pci->dev, "failed to set interconnect bandwidth: %d\n",
+        dev_err(pci->dev, "Failed to set bandwidth for PCIe-MEM interconnect path: %d\n",
              ret);
      }
  }





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux