Re: [PATCH v2 2/3] leds: sy7802: Add support for Silergy SY7802 flash LED controller

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, 02 May 2024, André Apitzsch wrote:

> Am Donnerstag, dem 02.05.2024 um 10:10 +0100 schrieb Lee Jones:
> > On Wed, 01 May 2024, André Apitzsch wrote:
> > 
> > > > > +		ret = -EBUSY;
> > > > > +		goto unlock;
> > > > > +	}
> > > > > +
> > > > > +	if (level)
> > > > > +		curr = chip->fled_torch_used | BIT(led-
> > > > > >led_no);
> > > > > +	else
> > > > > +		curr = chip->fled_torch_used & ~BIT(led-
> > > > > >led_no);
> > > > > +
> > > > > +	if (curr)
> > > > > +		val |= SY7802_MODE_TORCH;
> > > > > +
> > > > > +	/* Torch needs to be disabled first to apply new
> > > > > brightness */
> > > > 
> > > > "Disable touch to apply brightness"
> > > > 
> > > > > +	ret = regmap_update_bits(chip->regmap,
> > > > > SY7802_REG_ENABLE,
> > > > > SY7802_MODE_MASK,
> > > > > +				 SY7802_MODE_OFF);
> > > > > +	if (ret)
> > > > > +		goto unlock;
> > > > > +
> > > > > +	mask = led->led_no == SY7802_LED_JOINT ?
> > > > > SY7802_TORCH_CURRENT_MASK_ALL :
> > > > 
> > > > Why not just use led->led_no in place of mask?
> > > 
> > > I might be missing something, but I don't know how to use led-
> > > >led_no
> > > in place of mask, when
> > > led->led_no is in {0,1,2} and
> > > mask is in {0x07, 0x38, 0x3f}.
> > 
> > This doesn't make much sense.
> > 
> > I guess you mean that led_no is a u8 and mask is a u32.
> > 
> > What happens if you cast led_no to u32 in the call to
> > regmap_update_bits()?
> 
> Sorry, I'm still confused. Could you elaborate your original question?

Replied where there is still context.

-- 
Lee Jones [李琼斯]




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux