This comment one line down references a single, "same CTL" that controls
two interfaces, so the comment should clearly describe two interfaces
used with a single active CTL and not "two CTLs".
Fixes: 25fdd5933e4c ("drm/msm: Add SDM845 DPU support")
Signed-off-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
---
drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
index d9e7dbf0499c..7e849fe74801 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
@@ -428,7 +428,7 @@ static void dpu_encoder_phys_vid_enable(struct dpu_encoder_phys *phys_enc)
dpu_encoder_phys_vid_setup_timing_engine(phys_enc);
/*
- * For single flush cases (dual-ctl or pp-split), skip setting the
+ * For single flush cases (dual-intf or pp-split), skip setting the
* flush bit for the slave intf, since both intfs use same ctl
* and HW will only flush the master.
*/
--
2.44.0
