Re: [PATCH V5 RESEND 5/5] venus: pm_helpers: Use dev_pm_genpd_set_hwmode to switch GDSC mode on V6

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 4/14/2024 6:09 PM, Bryan O'Donoghue wrote:
On 13/04/2024 16:20, Jagadeesh Kona wrote:
The Venus driver requires vcodec GDSC to be ON in SW mode for clock
operations and move it back to HW mode to gain power benefits. Earlier,
as there is no interface to switch the GDSC mode from GenPD framework,
the GDSC is moved to HW control mode as part of GDSC enable callback and
venus driver is writing to its POWER_CONTROL register to keep the GDSC ON
from SW whereever required. But the POWER_CONTROL register addresses
are not constant and can vary across the variants.

Also as per the HW recommendation, the GDSC mode switching needs to be
controlled from respective GDSC register and this is a uniform approach
across all the targets. Hence use dev_pm_genpd_set_hwmode() API which
controls GDSC mode switching using its respective GDSC register.

In venus V6 variants, the vcodec gdsc gets enabled in SW mode by default
with new HW_CTRL_TRIGGER flag and there is no need to switch it to SW
mode again after enable, hence add check to avoid switching gdsc to SW mode again after gdsc enable. Similarly add check to avoid switching GDSC to HW mode before disabling the GDSC, so GDSC gets enabled in SW mode in the next
enable.

Signed-off-by: Jagadeesh Kona <quic_jkona@xxxxxxxxxxx>
Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx>
---

When I tested this out on sm8250 a few months ago it was broken.

I don't quite see in your commit logs, how the breakage was addressed.

Can you provide some details ?


Thanks Bryan for your review!

In earlier series, venus driver is switching the vcodec GDSC to HW control mode before disabling the GDSC by invoking vcodec_control_v4(..., false) in poweroff_coreid(). Due to this, the subsequent GDSC enable from venus driver is failing while polling for GDSC power ON status, since GDSC is under HW control mode and HW can keep the GDSC in disabled state.

Now a check is added in poweroff_coreid() to avoid switching the GDSC to HW control mode before disabling the GDSC for Venus V6 variants that use this new API. Hence during the next GDSC enable, GDSC will be in SW mode and GDSC will powerup properly.

Thanks,
Jagadeesh

---
bod





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux