On 4/7/24 12:48, Alex G. wrote:
On 3/8/24 03:17, Md Sadre Alam wrote:
Add qpic spi nand driver support. The spi nand
driver currently supported the below commands.
-- RESET
-- READ ID
-- SET FEATURE
-- GET FEATURE
-- READ PAGE
-- WRITE PAGE
-- ERASE PAGE
Co-developed-by: Sricharan Ramabadhran <quic_srichara@xxxxxxxxxxx>
Signed-off-by: Sricharan Ramabadhran <quic_srichara@xxxxxxxxxxx>
Co-developed-by: Varadarajan Narayanan <quic_varada@xxxxxxxxxxx>
Signed-off-by: Varadarajan Narayanan <quic_varada@xxxxxxxxxxx>
Signed-off-by: Md Sadre Alam <quic_mdalam@xxxxxxxxxxx>
---
For the entire series:
Tested-by: Alexandru Gagniuc <mr.nuke.me@xxxxxxxxx>
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index bc7021da2fe9..63764e943d82 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -882,6 +882,14 @@ config SPI_QCOM_QSPI
help
QSPI(Quad SPI) driver for Qualcomm QSPI controller.
+config SPI_QPIC_SNAND
+ tristate "QPIC SNAND controller"
Also, don't tristate this. It can be set as CONFIG_QPIC_COMMON=m, which
will cause the build to fail because you don't have a MODULE_LICENSE().
+ depends on ARCH_QCOM || COMPILE_TEST
Here, it needs to 'select QPIC_COMMON`. Otherwise it can run into
unresolved symbols:
: drivers/spi/spi-qpic-snand.o: in function `snandc_set_reg':
drivers/spi/spi-qpic-snand.c:56:(.text+0x484): undefined reference to
`qcom_offset_to_nandc_reg'
...
+ help
+ QPIC_SNAND (QPIC SPI NAND) driver for Qualcomm QPIC controller.
+ QPIC controller supports both parallel nand and serial nand.
+ This config will enable serial nand driver for QPIC controller.
+
config SPI_QUP
tristate "Qualcomm SPI controller with QUP interface"
depends on ARCH_QCOM || COMPILE_TEST
Alex
Alex
