On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge
for each controller instance. Hence, add a node to represent the bridge.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi | 30 ++++++++++++++++++++++++++++++
1 file changed, 30 insertions(+)
diff --git a/arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi b/arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi
index 2eb6758b6a3a..f128510d8445 100644
--- a/arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi
+++ b/arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi
@@ -1121,6 +1121,16 @@ pcie0: pcie@1b500000 {
status = "disabled";
perst-gpios = <&qcom_pinmux 3 GPIO_ACTIVE_LOW>;
+
+ pcie@0 {
+ device_type = "pci";
+ reg = <0x0 0x0 0x0 0x0 0x0>;
+ bus-range = <0x01 0xff>;
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+ };
};
pcie1: pcie@1b700000 {
@@ -1172,6 +1182,16 @@ pcie1: pcie@1b700000 {
status = "disabled";
perst-gpios = <&qcom_pinmux 48 GPIO_ACTIVE_LOW>;
+
+ pcie@0 {
+ device_type = "pci";
+ reg = <0x0 0x0 0x0 0x0 0x0>;
+ bus-range = <0x01 0xff>;
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+ };
};
pcie2: pcie@1b900000 {
@@ -1223,6 +1243,16 @@ pcie2: pcie@1b900000 {
status = "disabled";
perst-gpios = <&qcom_pinmux 63 GPIO_ACTIVE_LOW>;
+
+ pcie@0 {
+ device_type = "pci";
+ reg = <0x0 0x0 0x0 0x0 0x0>;
+ bus-range = <0x01 0xff>;
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+ };
};
qsgmii_csr: syscon@1bb00000 {
--
2.25.1
