misc_cmd_type in exec_op have multiple problems. With commit a82990c8a409
("mtd: rawnand: qcom: Add read/read_start ops in exec_op path") it was
reworked and generalized but actually dropped the handling of the
RESET_DEVICE command.
The rework itself was correct with supporting case where a single misc
command is handled, but became problematic by the addition of exiting
early if we didn't had an ERASE or an OP_PROGRAM_PAGE operation.
Also additional logic was added without clear explaination causing the
erase command to be broken on testing it on a ipq806x nandc.
Add some additional logic to restore RESET_DEVICE command handling and
fix erase command.
Fixes: a82990c8a409 ("mtd: rawnand: qcom: Add read/read_start ops in exec_op path")
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Christian Marangi <ansuelsmth@xxxxxxxxx>
---
drivers/mtd/nand/raw/qcom_nandc.c | 7 +++----
1 file changed, 3 insertions(+), 4 deletions(-)
diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index b079605c84d3..b8cff9240b28 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -2815,7 +2815,7 @@ static int qcom_misc_cmd_type_exec(struct nand_chip *chip, const struct nand_sub
host->cfg0_raw & ~(7 << CW_PER_PAGE));
nandc_set_reg(chip, NAND_DEV0_CFG1, host->cfg1_raw);
instrs = 3;
- } else {
+ } else if (q_op.cmd_reg != OP_RESET_DEVICE) {
return 0;
}
@@ -2830,9 +2830,8 @@ static int qcom_misc_cmd_type_exec(struct nand_chip *chip, const struct nand_sub
nandc_set_reg(chip, NAND_EXEC_CMD, 1);
write_reg_dma(nandc, NAND_FLASH_CMD, instrs, NAND_BAM_NEXT_SGL);
- (q_op.cmd_reg == OP_BLOCK_ERASE) ? write_reg_dma(nandc, NAND_DEV0_CFG0,
- 2, NAND_BAM_NEXT_SGL) : read_reg_dma(nandc,
- NAND_FLASH_STATUS, 1, NAND_BAM_NEXT_SGL);
+ if (q_op.cmd_reg == OP_BLOCK_ERASE)
+ write_reg_dma(nandc, NAND_DEV0_CFG0, 2, NAND_BAM_NEXT_SGL);
write_reg_dma(nandc, NAND_EXEC_CMD, 1, NAND_BAM_NEXT_SGL);
read_reg_dma(nandc, NAND_FLASH_STATUS, 1, NAND_BAM_NEXT_SGL);
--
2.43.0
