Hello,
This series enables D3 support for PCI bridges found in Qcom SoCs. Currently,
PCI core will enable D3 support for PCI bridges only when the following
conditions are met:
1. Platform is ACPI based
2. Thunderbolt controller is used
3. pcie_port_pm=force passed in cmdline
While options 1 and 2 do not apply to Qcom SoCs, option 3 will make the life
harder for distro maintainers. Due to this, runtime PM is also not getting
enabled for the bridges.
Ideally, D3 support should be enabled by default for the recent PCI bridges,
but we do not have a sane way to detect them. So this series adds a new flag
"bridge_d3_capable" to "struct pci_dev" which could be set by the bridge drivers
for capable devices. This will allow the PCI core to enable D3 support for the
bridges during enumeration.
In the Qcom controller driver, this flag is only set for recent bridges with PID
(0x0110).
Testing
=======
This series is tested on SM8450 based development board.
- Mani
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
---
Manivannan Sadhasivam (2):
PCI: Add a flag to enable D3 support for PCI bridges
PCI: qcom: Enable D3 support for the recent PCI bridges
drivers/pci/controller/dwc/pcie-qcom.c | 6 ++++++
drivers/pci/pci.c | 3 +++
include/linux/pci.h | 1 +
3 files changed, 10 insertions(+)
---
base-commit: 6613476e225e090cc9aad49be7fa504e290dd33d
change-id: 20240131-pcie-qcom-bridge-b6802a9770a3
Best regards,
--
Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
