qca808x PHY provide support for the led_polarity_set OP to configure
and apply the active-low property but on PHY reset, the Active High bit
is not set resulting in the LED driven as active-low.
To fix this, check if active-low is not set in DT and enable Active High
polarity by default to restore correct funcionality of the LED.
Fixes: 7196062b64ee ("net: phy: at803x: add LED support for qca808x")
Signed-off-by: Christian Marangi <ansuelsmth@xxxxxxxxx>
---
drivers/net/phy/qcom/qca808x.c | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/drivers/net/phy/qcom/qca808x.c b/drivers/net/phy/qcom/qca808x.c
index 00db4b274264..d88e04278fc4 100644
--- a/drivers/net/phy/qcom/qca808x.c
+++ b/drivers/net/phy/qcom/qca808x.c
@@ -290,8 +290,18 @@ static int qca808x_probe(struct phy_device *phydev)
static int qca808x_config_init(struct phy_device *phydev)
{
+ struct qca808x_priv *priv = phydev->priv;
int ret;
+ /* Default to LED Active High if active-low not in DT */
+ if (priv->led_polarity_mode == -1) {
+ ret = phy_set_bits_mmd(phydev, MDIO_MMD_AN,
+ QCA808X_MMD7_LED_POLARITY_CTRL,
+ QCA808X_LED_ACTIVE_HIGH);
+ if (ret)
+ return ret;
+ }
+
/* Active adc&vga on 802.3az for the link 1000M and 100M */
ret = phy_modify_mmd(phydev, MDIO_MMD_PCS, QCA808X_PHY_MMD3_ADDR_CLD_CTRL7,
QCA808X_8023AZ_AFE_CTRL_MASK, QCA808X_8023AZ_AFE_EN);
--
2.43.0
