Until now, all platform that supported both eDP and DP had different compatibles for each mode. Using different compatibles for basically the same IP block but for a different configuration is bad way all around. There is a new compute platform from Qualcomm that supports both eDP and DP with the same PHY. So instead of following the old method, we should allow the submode to be configured via set_mode from the controller driver. The controller part will follow after we conclude the PHY part first. Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx> --- Changes in v3: - Dropped needs_swing_pre_emph_cfg as we store the table instead - Picking the table based on is_edp instead of overriding. - Link to v2: https://lore.kernel.org/r/20231222-x1e80100-phy-edp-compatible-refactor-v2-0-ab5786c2359f@xxxxxxxxxx Changes in v2: - Dropped the dedicated xlate function and added set_mode op instead - Dropped the eDP PHY type and mode addition - Added the DP PHY submodes (eDP and DP) - Removed the device match data storing from the container struct - Link to v1: https://lore.kernel.org/r/20231219-x1e80100-phy-edp-compatible-refactor-v1-0-f9e77752953d@xxxxxxxxxx Initial attepmpt was here: https://lore.kernel.org/all/20231122-phy-qualcomm-edp-x1e80100-v3-3-576fc4e9559d@xxxxxxxxxx/ Compared to that version, this one uses the phy-cells method and drops the X1E80100 support. The X1E80100 support will be a separate patchset. --- Abel Vesa (2): phy: Add Embedded DisplayPort and DisplayPort submodes phy: qcom: edp: Add set_mode op for configuring eDP/DP submode drivers/phy/qualcomm/phy-qcom-edp.c | 71 ++++++++++++++++++++++++++----------- include/linux/phy/phy-dp.h | 3 ++ 2 files changed, 54 insertions(+), 20 deletions(-) --- base-commit: 72dd5696a6a27d019a1592acbca13263a2ebbac6 change-id: 20231219-x1e80100-phy-edp-compatible-refactor-8733eca7ccda Best regards, -- Abel Vesa <abel.vesa@xxxxxxxxxx>
