Re: [PATCH 0/9] PCI: introduce the concept of power sequencing of PCIe devices

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Jan 19, 2024 at 10:34 AM Lukas Wunner <lukas@xxxxxxxxx> wrote:
>
> On Fri, Jan 19, 2024 at 12:52:00PM +0100, Bartosz Golaszewski wrote:
> > We have two separate issues: one is powering-up a PCI device so that
> > it can be detected
>
> Just wondering, I note in really_probe() we configure the pin controller,
> active the pm_domain etc before probing a driver.
>
> Would it make sense for the issue you mention above to similarly
> amend pci_scan_device() to enable whatever clocks or regulators
> are described in the devicetree as providers for the given PCI device?

If you mean via a callback to some device specific code, then yes, I
think that's exactly what should be done here. That's roughly what
MDIO does. If firmware says there is a device present, then probe it
anyways even if not detected. I don't think that will work for PCI
because it accesses a lot of registers before probe. We'd need some
sort of pre-probe hook instead called after reading vendor and device
ID, but before anything else.

If you mean PCI core just enable whatever clocks and regulators (and
GPIOs), then no, because what is the correct order and timing for each
of those? You don't know because that is device specific information
just as how to program a device is.

Rob





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux