From: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
Describe the ath12k WLAN on-board the WCN7850 module present on the
board.
Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
[Bartosz:
- move the pcieport0 node into the .dtsi
- make regulator naming consistent with existing DT code
- add commit message]
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sm8650-qrd.dts | 29 +++++++++++++++++++++++++
arch/arm64/boot/dts/qcom/sm8650.dtsi | 10 +++++++++
2 files changed, 39 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sm8650-qrd.dts b/arch/arm64/boot/dts/qcom/sm8650-qrd.dts
index 592a67a47c78..5f960d90e7d2 100644
--- a/arch/arm64/boot/dts/qcom/sm8650-qrd.dts
+++ b/arch/arm64/boot/dts/qcom/sm8650-qrd.dts
@@ -513,6 +513,28 @@ &pcie0 {
status = "okay";
};
+&pcieport0 {
+ wifi@0 {
+ compatible = "pci17cb,1107";
+ reg = <0x10000 0x0 0x0 0x0 0x0>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&wlan_en>;
+
+ enable-gpios = <&tlmm 16 GPIO_ACTIVE_HIGH>;
+
+ vddio12-supply = <&vreg_l3c_1p2>;
+ vddio-supply = <&vreg_l15b_1p8>;
+ vdd-supply = <&vreg_s4i_0p85>;
+ vddaon-supply = <&vreg_s2c_0p8>;
+ vdddig-supply = <&vreg_s3c_0p9>;
+ vddrfa1-supply = <&vreg_s6c_1p8>;
+ vddrfa2-supply = <&vreg_s1c_1p2>;
+
+ clocks = <&rpmhcc RPMH_RF_CLK1>;
+ };
+};
+
&pcie0_phy {
vdda-phy-supply = <&vreg_l1i_0p88>;
vdda-pll-supply = <&vreg_l3i_1p2>;
@@ -718,6 +740,13 @@ ts_reset: ts-reset-state {
drive-strength = <8>;
bias-pull-up;
};
+
+ wlan_en: wlan-en-state {
+ pins = "gpio16";
+ function = "gpio";
+ drive-strength = <8>;
+ bias-pull-down;
+ };
};
&uart14 {
diff --git a/arch/arm64/boot/dts/qcom/sm8650.dtsi b/arch/arm64/boot/dts/qcom/sm8650.dtsi
index 2df77123a8c7..1da8b7844224 100644
--- a/arch/arm64/boot/dts/qcom/sm8650.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8650.dtsi
@@ -2270,6 +2270,16 @@ &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
dma-coherent;
status = "disabled";
+
+ pcieport0: pcie@0 {
+ device_type = "pci";
+ reg = <0x0 0x0 0x0 0x0 0x0>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+
+ bus-range = <0x01 0xff>;
+ };
};
pcie0_phy: phy@1c06000 {
--
2.40.1
