Each RPMh VREG accelerator resource has 3 or 4 contiguous 4-byte aligned
addresses associated with it. These control voltage, enable state, mode,
and in legacy targets, voltage headroom. The current in-flight request
checking logic looks for exact address matches. Requests for different
addresses of the same RPMh resource as thus not detected as in-flight.
Enhance the in-flight request check for VREG requests by ignoring the
address offset. This ensures that only one request is allowed to be
in-flight for a given VREG resource. This is needed to avoid scenarios
where request commands are carried out by RPMh hardware out-of-order
leading to LDO regulator over-current protection triggering.
Signed-off-by: Maulik Shah <quic_mkshah@xxxxxxxxxxx>
Signed-off-by: Elliot Berman <quic_eberman@xxxxxxxxxxx>
---
drivers/soc/qcom/rpmh-rsc.c | 20 +++++++++++++++++++-
1 file changed, 19 insertions(+), 1 deletion(-)
diff --git a/drivers/soc/qcom/rpmh-rsc.c b/drivers/soc/qcom/rpmh-rsc.c
index a021dc71807b..5371d7e3090a 100644
--- a/drivers/soc/qcom/rpmh-rsc.c
+++ b/drivers/soc/qcom/rpmh-rsc.c
@@ -1,6 +1,7 @@
// SPDX-License-Identifier: GPL-2.0
/*
* Copyright (c) 2016-2018, The Linux Foundation. All rights reserved.
+ * Copyright (c) 2023-2024, Qualcomm Innovation Center, Inc. All rights reserved.
*/
#define pr_fmt(fmt) "%s " fmt, KBUILD_MODNAME
@@ -91,6 +92,15 @@ enum {
#define CMD_STATUS_ISSUED BIT(8)
#define CMD_STATUS_COMPL BIT(16)
+#define ACCL_TYPE(addr) ((addr >> 16) & 0xF)
+#define VREG_ADDR(addr) (addr & ~0xF)
+
+enum {
+ HW_ACCL_CLK = 0x3,
+ HW_ACCL_VREG,
+ HW_ACCL_BUS,
+};
+
/*
* Here's a high level overview of how all the registers in RPMH work
* together:
@@ -557,7 +567,15 @@ static int check_for_req_inflight(struct rsc_drv *drv, struct tcs_group *tcs,
for_each_set_bit(j, &curr_enabled, MAX_CMDS_PER_TCS) {
addr = read_tcs_cmd(drv, drv->regs[RSC_DRV_CMD_ADDR], i, j);
for (k = 0; k < msg->num_cmds; k++) {
- if (addr == msg->cmds[k].addr)
+ /*
+ * Each RPMh VREG accelerator resource has 3 or 4 contiguous 4-byte
+ * aligned addresses associated with it. Ignore the offset to check
+ * for in-flight VREG requests.
+ */
+ if (HW_ACCL_VREG == ACCL_TYPE(msg->cmds[k].addr) &&
+ VREG_ADDR(addr) == VREG_ADDR(msg->cmds[k].addr))
+ return -EBUSY;
+ else if (addr == msg->cmds[k].addr)
return -EBUSY;
}
}
---
base-commit: 943b9f0ab2cfbaea148dd6ac279957eb08b96904
change-id: 20240117-rpmh-rsc-fixes-6c43c7051828
Best regards,
--
Maulik Shah <quic_mkshah@xxxxxxxxxxx>
