Re: [PATCH 0/6] Add PPE device tree node for Qualcomm IPQ SoC

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 1/10/2024 8:13 PM, Krzysztof Kozlowski wrote:
On 10/01/2024 12:20, Luo Jie wrote:
The PPE(packet process engine) hardware block is supported by Qualcomm
IPQ platforms, such as IPQ9574 and IPQ5332. The PPE includes the various
packet processing modules such as the routing and bridging flow engines,
L2 switch capability, VLAN and tunnels. Also included are integrated
ethernet MAC and PCS(uniphy), which is used to connect with the external
PHY devices by PCS.

This patch series enables support for the following DTSI functionality
for Qualcomm IPQ9574 and IPQ5332 chipsets.

1. Add PPE (Packet Processing Engine) HW support

2. Add IPQ9574 RDP433 board support, where the PPE is connected
    with qca8075 PHY and AQ PHY.

3. Add IPQ5332 RDP441 board support, where the PPE is connected
    with qca8386 and SFP

PPE DTS depends on the NSSCC clock driver below, which provides the
clocks for the PPE driver.

DTS cannot depend on clock drivers. Maybe you meant that it depends on
NSSCC clock controller DTS changes, which would be fine. However
depending on drivers is neither necessary nor allowed.

Best regards,
Krzysztof


Yes, this DTSI series depends on the NSSCC clock controller DTS patches which are referred to in the cover letter. I will rectify the cover letter text when the series resumes later.





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux