On 11/01/2024 18:38, Krishna Chaitanya Chundru wrote: > Hi DT maintainers, > > We are trying to upstream the QCOM PCIe switch which has I2C interface > to configure the switch. > > In generic a PCIe switch is a device that allows expansion of PCI > Express hierarchy, which allows more devices(PCIe endpoints) to be > connected to a single PCIe port. > > We need to configure the QCOM switch like L0s, L1ss entry times, Tx > amplitudes etc.. through I2C interface before PCIe link is established > as these settings can affect link stability if we don't configure them. > > Once PCIe switch is configured, PCIe link between the PCIe switch and > PCIe port connected should be established by the QCOM PCIe controller > driver to enumerate the PCIe endpoints connected to the PCIe switch. > > We had a QCOM switch driver which powers on the switch and do the I2C > configurations. > > This is how the flow goes. > -->Power on the switch > -->Do Switch configuration (over i2c) with qcom switch driver > -->PCIe link training and enumeration. And where is the PCI controller in this? Why isn't this represented like I2C or GPIO expander? You need to describe what exactly the switch is doing. Also, how about using existing solutions? Aren't there any? I am not going to look for them for you... Anyway, you should ask (means Cc) reset controller maintainers if they are happy for such usage of reset framework for something not being a reset. For similar reasons you should Cc PCI maintainers. If you ask me, then no, PCI switch does not look like reset line so, you should not use reset lines. Best regards, Krzysztof
