On 12/5/2015 2:58 AM, Vinod Koul wrote:
> On Tue, Dec 01, 2015 at 11:57:34PM -0500, Sinan Kaya wrote:
>> On 11/30/2015 10:17 PM, Vinod Koul wrote:
>>> On Mon, Nov 30, 2015 at 09:42:01AM -0500, Sinan Kaya wrote:
>>>
>>>>>> +static int hidma_mgmt_probe(struct platform_device *pdev)
>>>>>> +{
>>>>>> + struct hidma_mgmt_dev *mgmtdev;
>>>>>> + struct resource *res;
>>>>>> + void __iomem *virtaddr;
>>>>>> + int irq;
>>>>>> + int rc;
>>>>>> + u32 val;
>>>>>> +
>>>>>> + pm_runtime_set_autosuspend_delay(&pdev->dev, AUTOSUSPEND_TIMEOUT);
>>>>>> + pm_runtime_use_autosuspend(&pdev->dev);
>>>>>> + pm_runtime_set_active(&pdev->dev);
>>>>>> + pm_runtime_enable(&pdev->dev);
>>>>>
>>>>> at this time pm core will treat device as fully enabled and pm methods can
>>>>> be invoked, but you are not ready yet right. Typically these are done at the
>>>>> end of the probe unless you have a reason...
>>>>
>>>> I need it here because the clocks are declared as ACPI power resources.
>>>> The kernel is turning off all power resources during initialization. In
>>>> order for this code to touch the hardware, I need to call enable so that
>>>> clocks are enabled once again.
>>>
>>> The question is are you ready in your driver routines to be invoked by pm
>>> core?
>>>
>>
>> I don't have any support for suspend and resume PM APIs. The only PM
>> interface I support is PM runtime. PM can turn on/off the clocks based
>> on the reference counts it maintains after get/set APIs. Since PM is
>> turning off the clocks during power up before my driver load, I do need
>> to grab this lock to re-enable it during HW initialization. Then, let PM
>> turn off the clocks again after the AUTOSUSPEND_TIMEOUT when I'm done.
>>
>> Is there any other interaction with the PM that I'm not aware of?
>
> No this is fine. The the runtime_resume will be onvoked and it will request
> resources are those set before you enable the device?
>
Yes, the only resource that this device needs for power management is
the ACPI power resources. The device does not support suspend/resume via
traditional _PS0 and _PS3 calls. ACPI power resources are initialized
during power up while ACPI is being enumerated.
The probing of the HIDMA driver happens much afterwards.
--
Sinan Kaya
Qualcomm Technologies, Inc. on behalf of Qualcomm Innovation Center, Inc.
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, a
Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
