On 1/5/24 15:54, Luca Weiss wrote:
Configure the thermals for the PA_THERM1, MSM_THERM, PA_THERM0,
RFC_CAM_THERM, CAM_FLASH_THERM and QUIET_THERM thermistors connected to
PM6150L.
Due to hardware constraints we can only register 4 zones with
pm6150l_adc_tm, the other 2 we can register via generic-adc-thermal.
Ugh.. so the ADC can support more inputs than the ADC_TM that was
designed to ship alongside it can?
And that's why the "generic-adc-thermal"-provided zones need to
be polled?
The trip points can really only be considered as placeholders, more
configuration with cooling etc. can be added later.
Signed-off-by: Luca Weiss <luca.weiss@xxxxxxxxxxxxx>
---
[...]
I've read the sentence above, but..
+ sdm-skin-thermal {
+ polling-delay-passive = <1000>;
+ polling-delay = <5000>;
+ thermal-sensors = <&msm_therm_sensor>;
+
+ trips {
+ active-config0 {
+ temperature = <125000>;
+ hysteresis = <1000>;
+ type = "passive";
I don't fancy burnt fingers for dinner!
Konrad
