Re: [PATCH v2 0/2] phy: qcom: edp: Allow eDP/DP configuring via set_mode op

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 22.12.2023 14:01, Abel Vesa wrote:
> Until now, all platform that supported both eDP and DP had different
> compatibles for each mode. Using different compatibles for basically
> the same IP block but for a different configuration is bad way all
> around. There is a new compute platform from Qualcomm that supports
> both eDP and DP with the same PHY. So instead of following the old
> method, we should allow the mode to be configured via set_mode from
> the controller driver.
> 
> The controller part will follow after we conclude the PHY part first.
I got a bit lost between all the propositions, how are we going to
discern the controller modes going forward?

Konrad




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux