Add nodes for SMB2360 in separate dtsi file.
Also add the eUSB2 repeater nodes.
Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/smb2360.dtsi | 51 +++++++++++++++++++++++++++++++++++
1 file changed, 51 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/smb2360.dtsi b/arch/arm64/boot/dts/qcom/smb2360.dtsi
new file mode 100644
index 000000000000..782746a20403
--- /dev/null
+++ b/arch/arm64/boot/dts/qcom/smb2360.dtsi
@@ -0,0 +1,51 @@
+// SPDX-License-Identifier: BSD-3-Clause
+/*
+ * Copyright (c) 2023, Linaro Limited
+ */
+
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/spmi/spmi.h>
+
+/ {
+};
+
+&spmi1_bus {
+ smb2360h: pmic@7 {
+ compatible = "qcom,sm2360", "qcom,spmi-pmic";
+ reg = <0x7 SPMI_USID>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ smb2360_1_eusb2_repeater: phy@fd00 {
+ compatible = "qcom,smb2360-eusb2-repeater";
+ reg = <0xfd00>;
+ #phy-cells = <0>;
+ };
+ };
+
+ smb2360k: pmic@a {
+ compatible = "qcom,sm2360", "qcom,spmi-pmic";
+ reg = <0xa SPMI_USID>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ smb2360_2_eusb2_repeater: phy@fd00 {
+ compatible = "qcom,smb2360-eusb2-repeater";
+ reg = <0xfd00>;
+ #phy-cells = <0>;
+ };
+ };
+
+ smb2360l: pmic@b {
+ compatible = "qcom,sm2360", "qcom,spmi-pmic";
+ reg = <0xb SPMI_USID>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ smb2360_3_eusb2_repeater: phy@fd00 {
+ compatible = "qcom,smb2360-eusb2-repeater";
+ reg = <0xfd00>;
+ #phy-cells = <0>;
+ };
+ };
+};
---
base-commit: bbd220ce4e29ed55ab079007cff0b550895258eb
change-id: 20231201-x1e80100-dts-smb2360-0c7c25f2e0a7
Best regards,
--
Abel Vesa <abel.vesa@xxxxxxxxxx>
