On Wed, Nov 29, 2023 at 12:28:31AM -0800, Can Guo wrote: > Since HW ver 4, max HS gear can be get from UFS host controller's register, > use the max HS gear as the initial PHY gear instead of UFS_HS_G2, so that > we don't need to update the hard code for newer targets in future. > > Signed-off-by: Can Guo <quic_cang@xxxxxxxxxxx> One comment below. With that addressed, Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> > --- > drivers/ufs/host/ufs-qcom.c | 21 +++++++++++++++------ > 1 file changed, 15 insertions(+), 6 deletions(-) > > diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c > index aca6199..30f4ca6 100644 > --- a/drivers/ufs/host/ufs-qcom.c > +++ b/drivers/ufs/host/ufs-qcom.c > @@ -1060,6 +1060,20 @@ static void ufs_qcom_advertise_quirks(struct ufs_hba *hba) > hba->quirks |= UFSHCD_QUIRK_REINIT_AFTER_MAX_GEAR_SWITCH; > } > > +static void ufs_qcom_set_phy_gear(struct ufs_qcom_host *host) > +{ > + struct ufs_host_params *host_params = &host->host_params; > + > + host->phy_gear = host_params->hs_tx_gear; > + > + /* > + * Power up the PHY using the minimum supported gear (UFS_HS_G2). > + * Switching to max gear will be performed during reinit if supported. As I mentioned in v5, you need to reword this comment to make it clear we are setting G2 only for platforms < v4. Something like below: "For controllers whose major version is < 4, power up the PHY using minimum supported gear (UFS_HS_G2). Switching to max gear will be performed during reinit if supported. For newer controllers (>= 4), PHY will be powered up using max supported gear." - Mani > + */ > + if (host->hw_ver.major < 0x4) > + host->phy_gear = UFS_HS_G2; > +} > + > static void ufs_qcom_set_host_params(struct ufs_hba *hba) > { > struct ufs_qcom_host *host = ufshcd_get_variant(hba); > @@ -1296,6 +1310,7 @@ static int ufs_qcom_init(struct ufs_hba *hba) > ufs_qcom_set_caps(hba); > ufs_qcom_advertise_quirks(hba); > ufs_qcom_set_host_params(hba); > + ufs_qcom_set_phy_gear(host); > > err = ufs_qcom_ice_init(host); > if (err) > @@ -1313,12 +1328,6 @@ static int ufs_qcom_init(struct ufs_hba *hba) > dev_warn(dev, "%s: failed to configure the testbus %d\n", > __func__, err); > > - /* > - * Power up the PHY using the minimum supported gear (UFS_HS_G2). > - * Switching to max gear will be performed during reinit if supported. > - */ > - host->phy_gear = UFS_HS_G2; > - > return 0; > > out_variant_clear: > -- > 2.7.4 > > -- மணிவண்ணன் சதாசிவம்