Re: [PATCH v5 07/10] scsi: ufs: ufs-qcom: Set initial PHY gear to max HS gear for HW ver 5 and newer

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Mani,

On 11/28/2023 2:00 PM, Manivannan Sadhasivam wrote:
On Thu, Nov 23, 2023 at 12:46:27AM -0800, Can Guo wrote:
Set the initial PHY gear to max HS gear for hosts with HW ver 5 and newer.


MAX_GEAR will be used for hosts with hw_ver.major >= 4

I put it > 5 because I am not intent to touch any old targets which has proven working fine with starting with PHY gear HS_G2. If I put it >= 4, there would be many targets impacted by this change. I need to go back and test those platforms (HW ver == 4).

Thanks,
Can Guo.


This patch is not changing any functionalities or logic but only a
preparation patch for the next patch in this series.

Signed-off-by: Can Guo <quic_cang@xxxxxxxxxxx>
---
  drivers/ufs/host/ufs-qcom.c | 21 +++++++++++++++------
  1 file changed, 15 insertions(+), 6 deletions(-)

diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
index 6756f8d..7bbccf4 100644
--- a/drivers/ufs/host/ufs-qcom.c
+++ b/drivers/ufs/host/ufs-qcom.c
@@ -1067,6 +1067,20 @@ static void ufs_qcom_advertise_quirks(struct ufs_hba *hba)
  		hba->quirks |= UFSHCD_QUIRK_REINIT_AFTER_MAX_GEAR_SWITCH;
  }
+static void ufs_qcom_set_phy_gear(struct ufs_qcom_host *host)
+{
+	struct ufs_host_params *host_params = &host->host_params;
+
+	host->phy_gear = host_params->hs_tx_gear;
+
+	/*
+	 * Power up the PHY using the minimum supported gear (UFS_HS_G2).
+	 * Switching to max gear will be performed during reinit if supported.

You need to reword this comment too.

+	 */
+	if (host->hw_ver.major < 0x5)

As I mentioned above, MAX_GEAR will be used if hw_ver.major is >=4 in
ufs_qcom_get_hs_gear(). So this check should be (< 0x4).

- Mani

+		host->phy_gear = UFS_HS_G2;
+}
+
  static void ufs_qcom_set_host_params(struct ufs_hba *hba)
  {
  	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
@@ -1303,6 +1317,7 @@ static int ufs_qcom_init(struct ufs_hba *hba)
  	ufs_qcom_set_caps(hba);
  	ufs_qcom_advertise_quirks(hba);
  	ufs_qcom_set_host_params(hba);
+	ufs_qcom_set_phy_gear(host);
err = ufs_qcom_ice_init(host);
  	if (err)
@@ -1320,12 +1335,6 @@ static int ufs_qcom_init(struct ufs_hba *hba)
  		dev_warn(dev, "%s: failed to configure the testbus %d\n",
  				__func__, err);
- /*
-	 * Power up the PHY using the minimum supported gear (UFS_HS_G2).
-	 * Switching to max gear will be performed during reinit if supported.
-	 */
-	host->phy_gear = UFS_HS_G2;
-
  	return 0;
out_variant_clear:
--
2.7.4






[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux