On Thu, Nov 23, 2023 at 12:46:22AM -0800, Can Guo wrote:
> In ufs_qcom_pwr_change_notify(), host_params.hs_rate has been set to
> PA_HS_MODE_B by ufshcd_init_host_param(), hence remove the duplicated line
> of work. Meanwhile, removed the macro UFS_QCOM_LIMIT_HS_RATE as it is only
> used here.
>
> Signed-off-by: Can Guo <quic_cang@xxxxxxxxxxx>
Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
- Mani
> ---
> drivers/ufs/host/ufs-qcom.c | 1 -
> drivers/ufs/host/ufs-qcom.h | 2 --
> 2 files changed, 3 deletions(-)
>
> diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
> index aee66a3..cc30ad9 100644
> --- a/drivers/ufs/host/ufs-qcom.c
> +++ b/drivers/ufs/host/ufs-qcom.c
> @@ -909,7 +909,6 @@ static int ufs_qcom_pwr_change_notify(struct ufs_hba *hba,
> switch (status) {
> case PRE_CHANGE:
> ufshcd_init_host_param(&host_params);
> - host_params.hs_rate = UFS_QCOM_LIMIT_HS_RATE;
>
> /* This driver only supports symmetic gear setting i.e., hs_tx_gear == hs_rx_gear */
> host_params.hs_tx_gear = host_params.hs_rx_gear = ufs_qcom_get_hs_gear(hba);
> diff --git a/drivers/ufs/host/ufs-qcom.h b/drivers/ufs/host/ufs-qcom.h
> index 9950a00..82cd143 100644
> --- a/drivers/ufs/host/ufs-qcom.h
> +++ b/drivers/ufs/host/ufs-qcom.h
> @@ -27,8 +27,6 @@
> #define SLOW 1
> #define FAST 2
>
> -#define UFS_QCOM_LIMIT_HS_RATE PA_HS_MODE_B
> -
> /* QCOM UFS host controller vendor specific registers */
> enum {
> REG_UFS_SYS1CLK_1US = 0xC0,
> --
> 2.7.4
>
--
மணிவண்ணன் சதாசிவம்
