Re: [PATCH v13 05/10] usb: dwc3: qcom: Refactor IRQ handling in QCOM Glue driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




I didn't add missing interrupts on sc8280xp because I see that current
interrupts present are working fine (I see ADB working and wakeup
working as well), but the interrupt vector numbers are off by "1"
between hs specifics and DT (both upstream and downstream). Will sort it
out and clean that target up later.

Which interrupt numbers are off by one here?

My bad, this might be the confusion. The HW specifics say:

Controller-2, power_event irq:

SYS_apcsQgicSPI[812]		Vector-number: 843


Usually vector number = 32 + GIC number AFAIK.
By that logic, If vector number is 843, GIC_SPI number is 811 which is same as DT. Probably the GIC_SPI number is printed wrong. The DT matches (vector number - 32).

Sorry for mentioning that it is wrong. The DT entries are right and it is working on upstream.

The missing hs_phy_irq's have been put on the mail thread on this list before.

Regards,
Krishna,

[1]: https://patchwork.kernel.org/project/linux-arm-msm/list/?series=803412

I took a quick look at the series, and it looks like this will
eventually clean things up a lot. We should probably define a generic
order for the interrupts with the sometimes optional SS interrupts last.

Side note: It looks like the threading in that series is broken.
Consider using git-send-email for sending series as it takes care of
things like that.


Usually I do git send-email for the whole out folder where the patches are present, but linux-usb list is common to all the patches in that case, even the DT ones. So to avoid that and to send patches to only relavant mailing lists, I did git send email individually on each patch which might have caused this issue.

Will make sure this won't happen again.

Regards,
Krishna,





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux