QUP from version 2.1.1 onwards, supports a new format of i2c command tags.
Tag codes instructs the controller to perform a operation like read/write.
This new tagging version supports and is required for adding bam dma
capabilities. V2 tags supports transfer of more than 256 bytes in a single i2c
transaction. Also adding bam dma support facilitates transferring each i2c_msg
in i2c_msgs without a 'stop' bit in between which is required for some of
the clients.
Tested this series on apq8074 dragon board eeprom client on i2c bus1
[V5] Addressed few more comments from Ivan T. Ivanov.
Squashed patch 2 and 3 as no point in having only few lines of
common code between v1 and v2 tags for increased complexity.
Couple of non functional review comments fixes in patch 3, 4.
Added a change in patch 4 to have proper transfer completion in
a corner case. patch 5, 6 unchanged.
[V4] Added a patch to factor out some common code.
Removed support for freq > 400KHZ as per comments.
Addressed comments from Ivan T. Ivanov to keep the code for
V2 support in a separate path.
Changed the authorship of V2 tags support patch.
[V3] Added support to coalesce each i2c_msg in i2c_msgs for fifo and
block mode in Patch 2. Also addressed further code comments.
http://comments.gmane.org/gmane.linux.drivers.i2c/22497
[V2] Addressed comments from Ivan T. Ivanov, Andy Gross [v1] Initial Version
Sricharan R (6):
i2c: qup: Change qup_wait_writeready function to use for all timeouts
i2c: qup: Add V2 tags support
i2c: qup: Transfer each i2c_msg in i2c_msgs without a stop bit
i2c: qup: Add bam dma capabilities
dts: msm8974: Add blsp2_bam dma node
dts: msm8974: Add dma channels for blsp2_i2c1 node
arch/arm/boot/dts/qcom-msm8974.dtsi | 14 +-
drivers/i2c/busses/i2c-qup.c | 931 ++++++++++++++++++++++++++++++++++--
2 files changed, 896 insertions(+), 49 deletions(-)
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
