Re: [PATCH] arm64: dts: qcom: qrb2210-rb1: add wifi variant property

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 11/5/23 11:19, Dmitry Baryshkov wrote:
The RB1 platform doesn't have board-specific board-id programmed, it uses
generic 0xff. Thus add the property with the 'variant' of the
calibration data.

Note: the driver will check for the calibration data for the following
IDs, so existing board-2.bin files will continue to work.

- 'bus=snoc,qmi-board-id=ff,qmi-chip-id=120,variant=Thundercomm_RB1'
- 'bus=snoc,qmi-board-id=ff,qmi-chip-id=120'
- 'bus=snoc,qmi-board-id=ff'

For the reference, the board is identified by the driver in the
following way:

ath10k_snoc c800000.wifi: qmi chip_id 0x120 chip_family 0x4007 board_id 0xff soc_id 0x40670000
ath10k_snoc c800000.wifi: qmi fw_version 0x337302d3 fw_build_timestamp 2023-01-06 01:50 fw_build_id QC_IMAGE_VERSION_STRING=WLAN.HL.3.3.7.c2-00723-QCAHLSWMTPLZ-1
ath10k_snoc c800000.wifi: wcn3990 hw1.0 target 0x00000008 chip_id 0x00000000 sub 0000:0000
ath10k_snoc c800000.wifi: kconfig debug 0 debugfs 0 tracing 0 dfs 0 testmode 0
ath10k_snoc c800000.wifi: firmware ver  api 5 features wowlan,mgmt-tx-by-reference,non-bmi crc32 b3d4b790
ath10k_snoc c800000.wifi: htt-ver 3.114 wmi-op 4 htt-op 3 cal file max-sta 32 raw 0 hwcrypto 1

Fixes: 9692ccc49583 ("arm64: dts: qcom: qrb2210-rb1: Enable remote processors")
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---

Initially this patch was sent before Konrad actually sending the WiFi
support patchset for the RB1 board. Afterwards we didn't synchronise and
the calibration variant wasn't squashed into the relevant patchset.

---
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>

Konrad




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux