Re: [PATCH V3 0/3] Add APSS clock driver support for IPQ5018

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]


Hi everyone, a gentle remainder to review and acknowledge the change.


On 9/25/2023 3:58 PM, Gokul Sriram Palanisamy wrote:
This series adds support for the APSS clock to bump the CPU frequency
above 800MHz. APSS PLL found in the IPQ5018 is of type Stromer.

- The first patch in the series adds the required a53pll compatible.

- The second patch reuses Stormer Plus PLL offsets, adds configuration values
   for Stromer.

- The third patch adds dts nodes to enable the pll along with the cpu
   operating frequency table.

This series depends on below series

Changes in v3:
- Addressed review comment by Dmitry in patch 3.

Changes in v2:
- Addressed review comments
- Adds dependency on above mentioned patch series for dropping
   CLK_SET_RATE_PARENT flag from GPLL clocks, GPLL0 clock provider for
- Add CPU operating point at 800MHz based on the review comments.

Gokul Sriram Palanisamy (3):
   dt-bindings: clock: qcom,a53pll: add IPQ5018 compatible
   clk: qcom: apss-ipq-pll: add support for IPQ5018
   arm64: dts: qcom: ipq5018: enable the CPUFreq support

  .../bindings/clock/qcom,a53pll.yaml           |  1 +
  arch/arm64/boot/dts/qcom/ipq5018.dtsi         | 40 +++++++++++++++++++
  drivers/clk/qcom/apss-ipq-pll.c               | 21 ++++++++++
  3 files changed, 62 insertions(+)

[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux