Re: [RFC 6/8] arm: dts: qcom: Add pmic glink support for sm8450-qrd

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 10/27/2023 1:11 AM, Konrad Dybcio wrote:


On 10/17/23 15:18, Krishna Kurapati wrote:
Add Pmic Glink support for sm8450-qrd to facilitate passing
of roe switch notifications generated by ADSP to dwc3 core
via ucsi and pmic glink's.

Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
---
No phy+redriver+dp configuration?

Hi Konrad,

 Did you mean adding the following node:

        typec-mux@42 {
                compatible = "fcs,fsa4480";
                reg = <0x42>;

                interrupts-extended = <&tlmm 2 IRQ_TYPE_LEVEL_LOW>;

                vcc-supply = <&vreg_bob>;
                mode-switch;
                orientation-switch;

                port {
                        fsa4480_sbu_mux: endpoint {
                                remote-endpoint = <&pmic_glink_sbu>;
                        };
                };
        };


and then adding port-2 for pmic_glink ?

Usually for role-switch the port-0/1 defined in this patch are sufficient. Also if I added it, I don't have a way to currently test it. So skipped this node. I will try and see if I can test it and add it if possible.

Regards,
Krishna,



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux