During PISI test, we found the issue that host Tx still bursting after
H/W reset. Move ufs_qcom_host_reset() to ufs_qcom_device_reset() and
reset host before device reset to stop tx burst.
Signed-off-by: Ziqi Chen <quic_ziqichen@xxxxxxxxxxx>
---
drivers/ufs/host/ufs-qcom.c | 13 +++++++------
1 file changed, 7 insertions(+), 6 deletions(-)
diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
index 96cb8b5..43163d3 100644
--- a/drivers/ufs/host/ufs-qcom.c
+++ b/drivers/ufs/host/ufs-qcom.c
@@ -445,12 +445,6 @@ static int ufs_qcom_power_up_sequence(struct ufs_hba *hba)
struct phy *phy = host->generic_phy;
int ret;
- /* Reset UFS Host Controller and PHY */
- ret = ufs_qcom_host_reset(hba);
- if (ret)
- dev_warn(hba->dev, "%s: host reset returned %d\n",
- __func__, ret);
-
/* phy initialization - calibrate the phy */
ret = phy_init(phy);
if (ret) {
@@ -1709,6 +1703,13 @@ static void ufs_qcom_dump_dbg_regs(struct ufs_hba *hba)
static int ufs_qcom_device_reset(struct ufs_hba *hba)
{
struct ufs_qcom_host *host = ufshcd_get_variant(hba);
+ int ret = 0;
+
+ /* Reset UFS Host Controller and PHY */
+ ret = ufs_qcom_host_reset(hba);
+ if (ret)
+ dev_warn(hba->dev, "%s: host reset returned %d\n",
+ __func__, ret);
/* reset gpio is optional */
if (!host->device_reset)
--
2.7.4
