Re: [PATCH v2 4/6] arm64: dts: qcom: sm8350: Fix remoteproc interrupt type

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 10/19/23 06:06, Manivannan Sadhasivam wrote:
On Wed, Oct 18, 2023 at 10:17:15PM +0200, Konrad Dybcio wrote:


On 10/18/23 16:25, Nia Espera wrote:
In a similar vein to
https://lore.kernel.org/lkml/20220530080842.37024-3-manivannan.sadhasivam@xxxxxxxxxx/,
the remote processors on sm8350 fail to initialize with the 'correct'
(i.e., specified in downstream) IRQ type. Change this to EDGE_RISING.

Signed-off-by: Nia Espera <nespera@xxxxxxxxxx>
---
Hm, apparently 8250 and 7180 have the same thing.

Mani, could you elaborate on this?


So the remoteproc driver expects the wdog interrupts to be edge triggered as the
rest of the interrupts, but DT specifies them as level triggered. This won't
cause any issue during the first instance of the probe as the driver requested
trigger will be given precedence. But if the probe defers for some reason and
during the next try, request_irq() will fail with error similar to below:

irq: type mismatch, failed to map hwirq-x for interrupt-controller@xxxxxx!

This error is often confusing and I tried to fix it. But Maz didn't agree with
me, so I just ended up fixing the DTs for some platform I have access to.

So ideally, DTs of all platforms should be fixed to pass correct trigger type.
So, this should be edge for all platforms, correct?

Konrad



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux