On 13.10.2023 10:09, Luca Weiss wrote:
> Configure the thermals for the QUIET_THERM, CAM_FLASH_THERM, MSM_THERM
> and RFC_CAM_THERM thermistors connected to PM7325.
>
> With this PMIC the software communication to the ADC is going through
> PMK7325 (= PMK8350).
>
> Signed-off-by: Luca Weiss <luca.weiss@xxxxxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts | 117 +++++++++++++++++++++
> 1 file changed, 117 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts b/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> index 2c01f799a6b2..d0b1e4e507ff 100644
> --- a/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> +++ b/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> @@ -9,6 +9,7 @@
> #define PM7250B_SID 8
> #define PM7250B_SID1 9
>
> +#include <dt-bindings/iio/qcom,spmi-adc7-pm7325.h>
> #include <dt-bindings/iio/qcom,spmi-adc7-pmk8350.h>
> #include <dt-bindings/leds/common.h>
> #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
> @@ -137,6 +138,20 @@ afvdd_2p8: regulator-afvdd-2p8 {
> };
>
> thermal-zones {
> + camera-thermal {
> + polling-delay-passive = <0>;
> + polling-delay = <0>;
> + thermal-sensors = <&pmk8350_adc_tm 2>;
> +
> + trips {
> + active-config0 {
> + temperature = <125000>;
are
> + rear-cam-thermal {
> + temperature = <125000>;
you
> + sdm-skin-thermal {
> + temperature = <125000>;
sure
about these temps?
Konrad
