[PATCH 07/13] arm64: dts: qcom: msm8916-alcatel-idol347: Add sound and modem

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Vincent Knecht <vincent.knecht@xxxxxxxxxx>

Enable sound and modem for the Alcatel Idol 3 (4.7"). The setup is
similar to most MSM8916 devices, i.e.:

 - QDSP6 audio
 - Microphones via digital/analog codec in MSM8916/PM8916
 - WWAN Internet via BAM-DMUX

except:

 - Stereo NXP TFA9890 codecs for speakers on Quaternary MI2S
   - These are also used as earpieces at the top/bottom.
 - Asahi Kasei AK4375 headphone codec on Secondary MI2S
 -> Primary MI2S is not used for playback

Signed-off-by: Vincent Knecht <vincent.knecht@xxxxxxxxxx>
[Stephan: minor cleanup, add consistent commit message]
Signed-off-by: Stephan Gerhold <stephan@xxxxxxxxxxx>
---
There are some trivial conflicts unless
https://lore.kernel.org/linux-arm-msm/20230921-msm8916-rmem-fixups-v1-3-34d2b6e721cf@xxxxxxxxxxx/
is applied first. But given that there are important fixups for the
dynamic reserved memory changes in that series it should preferably
get applied before this one anyway.
---
 .../boot/dts/qcom/msm8916-alcatel-idol347.dts      | 164 +++++++++++++++++++++
 1 file changed, 164 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/msm8916-alcatel-idol347.dts b/arch/arm64/boot/dts/qcom/msm8916-alcatel-idol347.dts
index fade93c55299..ef5fc9289754 100644
--- a/arch/arm64/boot/dts/qcom/msm8916-alcatel-idol347.dts
+++ b/arch/arm64/boot/dts/qcom/msm8916-alcatel-idol347.dts
@@ -3,6 +3,8 @@
 /dts-v1/;
 
 #include "msm8916-pm8916.dtsi"
+#include "msm8916-modem-qdsp6.dtsi"
+
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/input/input.h>
 #include <dt-bindings/leds/common.h>
@@ -22,6 +24,19 @@ chosen {
 		stdout-path = "serial0";
 	};
 
+	reserved-memory {
+		/delete-node/ reserved@86680000;
+		/delete-node/ rmtfs@86700000;
+
+		rmtfs: rmtfs@86680000 {
+			compatible = "qcom,rmtfs-mem";
+			reg = <0x0 0x86680000 0x0 0x160000>;
+			no-map;
+
+			qcom,client-id = <1>;
+		};
+	};
+
 	gpio-keys {
 		compatible = "gpio-keys";
 
@@ -50,6 +65,17 @@ led-0 {
 		};
 	};
 
+	reg_headphones_avdd: regulator-headphones-avdd {
+		compatible = "regulator-fixed";
+		regulator-name = "headphones_avdd";
+		regulator-min-microvolt = <1800000>;
+		regulator-max-microvolt = <1800000>;
+		gpio = <&tlmm 121 GPIO_ACTIVE_HIGH>;
+		enable-active-high;
+		pinctrl-0 = <&headphones_avdd_default>;
+		pinctrl-names = "default";
+	};
+
 	usb_id: usb-id {
 		compatible = "linux,extcon-usb-gpio";
 		id-gpios = <&tlmm 69 GPIO_ACTIVE_HIGH>;
@@ -58,6 +84,43 @@ usb_id: usb-id {
 	};
 };
 
+&blsp_i2c3 {
+	status = "okay";
+
+	headphones: audio-codec@10 {
+		compatible = "asahi-kasei,ak4375";
+		reg = <0x10>;
+		avdd-supply = <&reg_headphones_avdd>;
+		tvdd-supply = <&pm8916_l6>;
+		pdn-gpios = <&tlmm 114 GPIO_ACTIVE_HIGH>;
+		pinctrl-0 = <&headphones_pdn_default>;
+		pinctrl-names = "default";
+		#sound-dai-cells = <0>;
+	};
+
+	speaker_codec_top: audio-codec@34 {
+		compatible = "nxp,tfa9897";
+		reg = <0x34>;
+		vddd-supply = <&pm8916_l6>;
+		rcv-gpios = <&tlmm 50 GPIO_ACTIVE_HIGH>;
+		pinctrl-0 = <&speaker_top_default>;
+		pinctrl-names = "default";
+		sound-name-prefix = "Speaker Top";
+		#sound-dai-cells = <0>;
+	};
+
+	speaker_codec_bottom: audio-codec@36 {
+		compatible = "nxp,tfa9897";
+		reg = <0x36>;
+		vddd-supply = <&pm8916_l6>;
+		rcv-gpios = <&tlmm 111 GPIO_ACTIVE_HIGH>;
+		pinctrl-0 = <&speaker_bottom_default>;
+		pinctrl-names = "default";
+		sound-name-prefix = "Speaker Bottom";
+		#sound-dai-cells = <0>;
+	};
+};
+
 &blsp_i2c4 {
 	status = "okay";
 
@@ -153,6 +216,18 @@ &blsp_uart2 {
 	status = "okay";
 };
 
+&mpss_mem {
+	reg = <0x0 0x86800000 0x0 0x5000000>;
+};
+
+&pm8916_codec {
+	qcom,micbias1-ext-cap;
+	qcom,micbias-lvl = <2800>;
+	qcom,mbhc-vthreshold-low = <75 100 120 180 500>;
+	qcom,mbhc-vthreshold-high = <75 100 120 180 500>;
+	qcom,hphl-jack-type-normally-open;
+};
+
 &pm8916_resin {
 	status = "okay";
 	linux,code = <KEY_VOLUMEDOWN>;
@@ -169,6 +244,17 @@ &pm8916_vib {
 	status = "okay";
 };
 
+&q6afedai {
+	dai@18 {
+		reg = <SECONDARY_MI2S_RX>;
+		qcom,sd-lines = <0>;
+	};
+	dai@22 {
+		reg = <QUATERNARY_MI2S_RX>;
+		qcom,sd-lines = <0>;
+	};
+};
+
 &sdhc_1 {
 	status = "okay";
 };
@@ -183,6 +269,47 @@ &sdhc_2 {
 	cd-gpios = <&tlmm 38 GPIO_ACTIVE_LOW>;
 };
 
+&sound {
+	status = "okay";
+
+	/* Add pin switches for speakers to allow disabling them individually */
+	model = "alcatel-idol3";
+	widgets =
+		"Speaker", "Speaker Top",
+		"Speaker", "Speaker Bottom";
+	pin-switches = "Speaker Top", "Speaker Bottom";
+	audio-routing =
+		"Speaker Top", "Speaker Top OUT",
+		"Speaker Bottom", "Speaker Bottom OUT",
+		"AMIC1", "MIC BIAS External1",
+		"AMIC2", "MIC BIAS Internal2",
+		"AMIC3", "MIC BIAS External1";
+
+	pinctrl-0 = <&cdc_pdm_default &pri_mi2s_default &pri_mi2s_ws_default &sec_mi2s_default>;
+	pinctrl-1 = <&cdc_pdm_sleep &pri_mi2s_sleep &pri_mi2s_ws_sleep &sec_mi2s_sleep>;
+	pinctrl-names = "default", "sleep";
+};
+
+&sound_dai_primary {
+	status = "disabled";
+};
+
+&sound_dai_quaternary {
+	status = "okay";
+
+	codec {
+		sound-dai = <&speaker_codec_top>, <&speaker_codec_bottom>;
+	};
+};
+
+&sound_dai_secondary {
+	status = "okay";
+
+	codec {
+		sound-dai = <&headphones>;
+	};
+};
+
 &usb {
 	status = "okay";
 	extcon = <&usb_id>, <&usb_id>;
@@ -212,6 +339,15 @@ &wcnss_mem {
 	status = "okay";
 };
 
+/* Only some of the pins are used */
+&pri_mi2s_default {
+	pins = "gpio113", "gpio115";
+};
+
+&pri_mi2s_sleep {
+	pins = "gpio113", "gpio115";
+};
+
 &tlmm {
 	accel_int_default: accel-int-default-state {
 		pins = "gpio31";
@@ -245,6 +381,20 @@ gyro_int_default: gyro-int-default-state {
 		bias-disable;
 	};
 
+	headphones_avdd_default: headphones-avdd-default-state {
+		pins = "gpio121";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
+	headphones_pdn_default: headphones-pdn-default-state {
+		pins = "gpio114";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
 	/*
 	 * The OEM wired an additional GPIO to be asserted so that
 	 * the si-en,sn3190 LED IC works. Since this GPIO is not
@@ -291,6 +441,20 @@ sdc2_cd_default: sdc2-cd-default-state {
 		bias-disable;
 	};
 
+	speaker_bottom_default: speaker-bottom-default-state {
+		pins = "gpio111";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
+	speaker_top_default: speaker-top-default-state {
+		pins = "gpio50";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
 	ts_int_reset_default: ts-int-reset-default-state {
 		pins = "gpio13", "gpio100";
 		function = "gpio";

-- 
2.42.0




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux