While the kernel is booting up, APSS PLL will be running at 800MHz with
GPLL0 as source. Once the cpufreq driver is available, APSS PLL will be
configured to the rate based on the opp table and the source also will
be changed to APSS_PLL_EARLY. So allow the mailbox to consume the GPLL0,
with this inclusion, CPU Freq correctly reports that CPU is running at
800MHz rather than 24MHz.
Signed-off-by: Kathiravan Thirumoorthy <quic_kathirav@xxxxxxxxxxx>
---
Changes in V2:
- Splitted the change into target specific file
---
arch/arm64/boot/dts/qcom/ipq9574.dtsi | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/ipq9574.dtsi b/arch/arm64/boot/dts/qcom/ipq9574.dtsi
index 51aba071c1eb..89edb4b852df 100644
--- a/arch/arm64/boot/dts/qcom/ipq9574.dtsi
+++ b/arch/arm64/boot/dts/qcom/ipq9574.dtsi
@@ -652,8 +652,8 @@ apcs_glb: mailbox@b111000 {
"qcom,ipq6018-apcs-apps-global";
reg = <0x0b111000 0x1000>;
#clock-cells = <1>;
- clocks = <&a73pll>, <&xo_board_clk>;
- clock-names = "pll", "xo";
+ clocks = <&a73pll>, <&xo_board_clk>, <&gcc GPLL0>;
+ clock-names = "pll", "xo", "gpll0";
#mbox-cells = <1>;
};
--
2.34.1
