On 09/18/15 15:32, Srinivas Kandagatla wrote:
> Add pwrseq support to sdcc4 which would enable a proper reset of WLAN
> without ugly hacks in the board support file.
>
> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
Thanks Srini!
Acked-by: Igor Grinberg <grinberg@xxxxxxxxxxxxxx>
> ---
> arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 32 +++++++++++++++++++++++++++++
> 1 file changed, 32 insertions(+)
>
> diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
> index 8aac3be..cc9d942 100644
> --- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
> +++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
> @@ -1,4 +1,6 @@
> #include "qcom-apq8064-v2.0.dtsi"
> +#include <dt-bindings/gpio/gpio.h>
> +#include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
>
> / {
> model = "CompuLab CM-QS600";
> @@ -12,6 +14,20 @@
> stdout-path = "serial0:115200n8";
> };
>
> + pwrseq {
> + #address-cells = <1>;
> + #size-cells = <1>;
> + ranges;
> + compatible = "simple-bus";
> +
> + sdcc4_pwrseq: sdcc4_pwrseq {
> + pinctrl-names = "default";
> + pinctrl-0 = <&wlan_default_gpios>;
> + compatible = "mmc-pwrseq-simple";
> + reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
> + };
> + };
> +
> soc {
> rpm@108000 {
> regulators {
> @@ -154,6 +170,21 @@
> regulator-always-on;
> };
>
> + qcom,ssbi@500000 {
> + pmic@0 {
> + gpio@150 {
> + wlan_default_gpios: wlan-gpios {
> + pios {
> + pins = "gpio43";
> + function = "normal";
> + bias-disable;
> + power-source = <PM8921_GPIO_S4>;
> + };
> + };
> + };
> + };
> + };
> +
> amba {
> /* eMMC */
> sdcc1: sdcc@12400000 {
> @@ -172,6 +203,7 @@
> status = "okay";
> vmmc-supply = <&v3p3_fixed>;
> vqmmc-supply = <&v3p3_fixed>;
> + mmc-pwrseq = <&sdcc4_pwrseq>;
> };
> };
> };
>
--
Regards,
Igor.
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
