On 28.08.2023 15:30, Krishna Kurapati wrote: > From: Andrew Halaney <ahalaney@xxxxxxxxxx> > > There is now support for the multiport USB controller this uses so > enable it. > > The board only has a single port hooked up (despite it being wired up to > the multiport IP on the SoC). There's also a USB 2.0 mux hooked up, > which by default on boot is selected to mux properly. Grab the gpio > controlling that and ensure it stays in the right position so USB 2.0 > continues to be routed from the external port to the SoC. > > Co-developed-by: Andrew Halaney <ahalaney@xxxxxxxxxx> > Signed-off-by: Andrew Halaney <ahalaney@xxxxxxxxxx> > [Krishna: Rebased on top of usb-next] > Co-developed-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx> > Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx> > --- Is there any benefit to removing the other ports? i.e. are ports 1-3 not parked properly by the dwc3 driver if they're never connected to anything? Konrad
