Change PM8921 node labels to start with pm8921_ prefix, following other Qualcomm PMIC device nodes. Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx> --- arch/arm/boot/dts/qcom/qcom-msm8960.dtsi | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/arch/arm/boot/dts/qcom/qcom-msm8960.dtsi b/arch/arm/boot/dts/qcom/qcom-msm8960.dtsi index a34fda93d6a4..ea2d961b266b 100644 --- a/arch/arm/boot/dts/qcom/qcom-msm8960.dtsi +++ b/arch/arm/boot/dts/qcom/qcom-msm8960.dtsi @@ -264,7 +264,7 @@ ssbi@500000 { reg = <0x500000 0x1000>; qcom,controller-type = "pmic-arbiter"; - pmicintc: pmic { + pm8921: pmic { compatible = "qcom,pm8921"; interrupt-parent = <&msmgpio>; interrupts = <104 IRQ_TYPE_LEVEL_LOW>; @@ -276,7 +276,7 @@ pmicintc: pmic { pwrkey@1c { compatible = "qcom,pm8921-pwrkey"; reg = <0x1c>; - interrupt-parent = <&pmicintc>; + interrupt-parent = <&pm8921>; interrupts = <50 IRQ_TYPE_EDGE_RISING>, <51 IRQ_TYPE_EDGE_RISING>; debounce = <15625>; @@ -286,7 +286,7 @@ pwrkey@1c { pm8921_keypad: keypad@148 { compatible = "qcom,pm8921-keypad"; reg = <0x148>; - interrupt-parent = <&pmicintc>; + interrupt-parent = <&pm8921>; interrupts = <74 IRQ_TYPE_EDGE_RISING>, <75 IRQ_TYPE_EDGE_RISING>; debounce = <15>; @@ -296,7 +296,7 @@ pm8921_keypad: keypad@148 { rtc@11d { compatible = "qcom,pm8921-rtc"; - interrupt-parent = <&pmicintc>; + interrupt-parent = <&pm8921>; interrupts = <39 IRQ_TYPE_EDGE_RISING>; reg = <0x11d>; allow-set-time; -- 2.39.2