Add pwrseq support to sdcc4 which would enable a proper reset of WLAN
without ugly hacks in the board support file.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
---
arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 32 +++++++++++++++++++++++++++++
1 file changed, 32 insertions(+)
diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
index 34ccb26..ebde2b7 100644
--- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
@@ -1,9 +1,25 @@
#include "qcom-apq8064-v2.0.dtsi"
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
/ {
model = "CompuLab CM-QS600";
compatible = "qcom,apq8064-cm-qs600", "qcom,apq8064";
+ pwrseq {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ compatible = "simple-bus";
+
+ sdcc4_pwrseq: sdcc4_pwrseq {
+ pinctrl-names = "default";
+ pinctrl-0 = <&wlan_default_gpios>;
+ compatible = "mmc-pwrseq-simple";
+ reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
+ };
+ };
+
soc {
pinctrl@800000 {
i2c1_pins: i2c1 {
@@ -155,6 +171,21 @@
regulator-always-on;
};
+ qcom,ssbi@500000 {
+ pmic@0 {
+ gpio@150 {
+ wlan_default_gpios: wlan-gpios {
+ pios {
+ pins = "gpio43";
+ function = "normal";
+ bias-disable;
+ power-source = <PM8921_GPIO_S4>;
+ };
+ };
+ };
+ };
+ };
+
amba {
/* eMMC */
sdcc1: sdcc@12400000 {
@@ -173,6 +204,7 @@
status = "okay";
vmmc-supply = <&v3p3_fixed>;
vqmmc-supply = <&v3p3_fixed>;
+ mmc-pwrseq = <&sdcc4_pwrseq>;
};
};
};
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
