On 30.06.2023 08:13, Dmitry Baryshkov wrote:
> Add thermal zones controlled through the ADC-TM (ADC thermal monitoring)
> PMIC interface. This includes several onboard sensors and the XO thermal
> sensor.
>
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> ---
[...]
>
> + channel@144 {
> + reg = <PM8350_ADC7_AMUX_THM1_100K_PU(1)>;
This define should be cleaned up.. Since it takes a sid argument,
it really is ADC7_AMUX_THM1_100K_PU(sid)
Konrad
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "skin_msm_temp";
> + };
> +
> + channel@145 {
> + reg = <PM8350_ADC7_AMUX_THM2_100K_PU(1)>;
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "camera_temp";
> + };
> +
> + channel@146 {
> + reg = <PM8350_ADC7_AMUX_THM3_100K_PU(1)>;
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "therm1_temp";
> + };
> +
> + channel@147 {
> + reg = <PM8350_ADC7_AMUX_THM4_100K_PU(1)>;
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "wide_rfc_temp";
> + };
> +
> + channel@148 {
> + reg = <PM8350_ADC7_AMUX_THM5_100K_PU(1)>;
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "rear_tof_temp";
> + };
> +
> + channel@14c {
> + reg = <PM8350_ADC7_GPIO3_100K_PU(1)>;
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "therm2_temp";
> + };
> +
> channel@303 {
> reg = <PM8350B_ADC7_DIE_TEMP>;
> label = "pm8350b_die_temp";
> };
>
> + channel@348 {
> + reg = <PM8350B_ADC7_AMUX_THM5_100K_PU>;
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "usb_conn_temp";
> + };
> +
> channel@403 {
> reg = <PMR735A_ADC7_DIE_TEMP>;
> label = "pmr735a_die_temp";
> };
> +
> + channel@44a {
> + reg = <PMR735A_ADC7_GPIO1_100K_PU>;
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "qtm_w_temp";
> + };
> +
> + channel@44b {
> + reg = <PMR735A_ADC7_GPIO2_100K_PU>;
> + qcom,hw-settle-time = <200>;
> + qcom,ratiometric;
> + label = "qtm_n_temp";
> + };
> };
>
> &remoteproc_adsp {
