Re: [PATCH v3 2/3] drm/msm/dpu: use dpu core's major version to enable data compress

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 29/06/2023 22:29, Abhinav Kumar wrote:
Instead of using a feature bit to decide whether to enable data
compress or not for DSC use-cases, use dpu core's major version instead.
This will avoid defining feature bits for every bit level details of
registers.

Also, rename the intf's enable_compression() op to program_datapath()
and allow it to accept a struct intf_dpu_datapath_cfg to program
all the bits at once. This can be re-used by widebus later on as
well as it touches the same register.

Two separate commits please, because...

Signed-off-by: Abhinav Kumar <quic_abhinavk@xxxxxxxxxxx>
---
  .../gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c |  9 +++++++--
  drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c      |  9 +++++----
  drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h      | 16 ++++++++++++++--
  3 files changed, 26 insertions(+), 8 deletions(-)

diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
index b856c6286c85..f4e15b4c4cc9 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
@@ -50,6 +50,7 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
  			to_dpu_encoder_phys_cmd(phys_enc);
  	struct dpu_hw_ctl *ctl;
  	struct dpu_hw_intf_cfg intf_cfg = { 0 };
+	struct dpu_kms *dpu_kms = phys_enc->dpu_kms;
ctl = phys_enc->hw_ctl;
  	if (!ctl->ops.setup_intf_cfg)
@@ -68,8 +69,12 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
  				phys_enc->hw_intf,
  				phys_enc->hw_pp->idx);
- if (intf_cfg.dsc != 0 && phys_enc->hw_intf->ops.enable_compression)
-		phys_enc->hw_intf->ops.enable_compression(phys_enc->hw_intf);
+	if (intf_cfg.dsc != 0 && dpu_kms->catalog->core_major_version >= 0x7) {

... because this becomes incorrect. The datapath should be programmed in all the cases, if there is a corresponding callback. intf_cfg.dsc should be used as a condition to set datapath_cfg.


+		struct intf_dpu_datapath_cfg datapath_cfg = { 0 };

No need for `0' in the init, empty braces would be enough.

+
+		datapath_cfg.data_compress = true;
+		phys_enc->hw_intf->ops.program_datapath(phys_enc->hw_intf, &datapath_cfg);
+	}
  }
static void dpu_encoder_phys_cmd_pp_tx_done_irq(void *arg, int irq_idx)
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
index 5b0f6627e29b..85333df08fbc 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
@@ -513,11 +513,13 @@ static void dpu_hw_intf_disable_autorefresh(struct dpu_hw_intf *intf,
} -static void dpu_hw_intf_enable_compression(struct dpu_hw_intf *ctx)
+static void dpu_hw_intf_program_datapath(struct dpu_hw_intf *ctx,
+					 struct intf_dpu_datapath_cfg *datapath_cfg)
  {
  	u32 intf_cfg2 = DPU_REG_READ(&ctx->hw, INTF_CONFIG2);
- intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS;
+	if (datapath_cfg->data_compress)
+		intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS;
DPU_REG_WRITE(&ctx->hw, INTF_CONFIG2, intf_cfg2);
  }
@@ -543,8 +545,7 @@ static void _setup_intf_ops(struct dpu_hw_intf_ops *ops,
  		ops->disable_autorefresh = dpu_hw_intf_disable_autorefresh;
  	}
- if (cap & BIT(DPU_INTF_DATA_COMPRESS))
-		ops->enable_compression = dpu_hw_intf_enable_compression;
+	ops->program_datapath = dpu_hw_intf_program_datapath;

The `core_major_version >= 7' should either be here or in the callback itself.

  }
struct dpu_hw_intf *dpu_hw_intf_init(const struct dpu_intf_cfg *cfg,
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
index 99e21c4137f9..f736dca38463 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
@@ -48,6 +48,11 @@ struct intf_status {
  	u32 line_count;		/* current line count including blanking */
  };
+struct intf_dpu_datapath_cfg {
+	u8 data_compress;	/* enable data compress between dpu and dsi */
+	/* can be expanded for other programmable bits */
+};

I'd say, dpu_datapath is too generic. What about  intf_cmd_mode_cfg?

+
  /**
   * struct dpu_hw_intf_ops : Interface to the interface Hw driver functions
   *  Assumption is these functions will be called after clocks are enabled
@@ -70,7 +75,7 @@ struct intf_status {
   * @get_autorefresh:            Retrieve autorefresh config from hardware
   *                              Return: 0 on success, -ETIMEDOUT on timeout
   * @vsync_sel:                  Select vsync signal for tear-effect configuration
- * @enable_compression:         Enable data compression
+ * @program_datapath:           Program the DPU to interface datapath for relevant chipsets
   */
  struct dpu_hw_intf_ops {
  	void (*setup_timing_gen)(struct dpu_hw_intf *intf,
@@ -108,7 +113,14 @@ struct dpu_hw_intf_ops {
  	 */
  	void (*disable_autorefresh)(struct dpu_hw_intf *intf, uint32_t encoder_id, u16 vdisplay);
- void (*enable_compression)(struct dpu_hw_intf *intf);
+	/**
+	 * Program the DPU to intf datapath by specifying
+	 * which of the settings need to be programmed for
+	 * use-cases which need DPU-intf handshake such as
+	 * widebus, compression etc.

This is not a valid kerneldoc.

+	 */
+	void (*program_datapath)(struct dpu_hw_intf *intf,
+				 struct intf_dpu_datapath_cfg *datapath_cfg);
  };
struct dpu_hw_intf {

--
With best wishes
Dmitry




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux